qlcnic: reset pci function unconditionally during probe
Some boot code drivers dont have cleanup routine, so pci function
remains in unknown state prior to driver load. So during driver load
issue FLR unconditionally.
Update driver version to 5.0.14.
Signed-off-by: Rajesh Borundia <rajesh.borundia@qlogic.com>
Signed-off-by: Amit Kumar Salecha <amit.salecha@qlogic.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/qlcnic/qlcnic_main.c b/drivers/net/qlcnic/qlcnic_main.c
index 788850e..11e3a46 100644
--- a/drivers/net/qlcnic/qlcnic_main.c
+++ b/drivers/net/qlcnic/qlcnic_main.c
@@ -1468,7 +1468,6 @@
uint8_t revision_id;
uint8_t pci_using_dac;
char brd_name[QLCNIC_MAX_BOARD_NAME_LEN];
- u32 val;
err = pci_enable_device(pdev);
if (err)
@@ -1530,9 +1529,7 @@
if (err)
goto err_out_iounmap;
- val = QLCRD32(adapter, QLCNIC_CRB_DRV_ACTIVE);
- if (QLC_DEV_CHECK_ACTIVE(val, adapter->portnum))
- adapter->flags |= QLCNIC_NEED_FLR;
+ adapter->flags |= QLCNIC_NEED_FLR;
err = adapter->nic_ops->start_firmware(adapter);
if (err) {