forcedeth: fix TX timeout caused by TX pause on down link
On some dual-port forcedeth devices such as MCP55 10de:0373 (rev a3),
when autoneg & TX pause are enabled while port is connected but
interface is down, the NIC will eventually freeze (TX timeouts,
network unreachable).
This patch ensures that TX pause is not configured in hardware when
interface is down. The TX pause request will be honored when interface
is later configured.
Tested:
- hardware is MCP55 device id 10de:0373 (rev a3), dual-port
- eth0 connected and UP, eth1 connected but DOWN
- without this patch, following sequence would brick NIC:
ifconfig eth0 down
ifconfig eth1 up
ifconfig eth1 down
ethtool -A eth1 autoneg off rx on tx off
ifconfig eth1 up
ifconfig eth1 down
ethtool -A eth1 autoneg on rx on tx on
ifconfig eth1 up
ifconfig eth1 down
ifup eth0
sleep 120 # or longer
ethtool eth1
Just in case, sequence to un-brick:
ifconfig eth0 down
ethtool -A eth1 autoneg off rx on tx off
ifconfig eth1 up
ifconfig eth1 down
ifup eth0
- with this patch: no TX timeout after "bricking" sequence above
Details:
- The following register accesses have been identified as the ones
causing the NIC to freeze in "bricking" sequence above:
- write NVREG_TX_PAUSEFRAME_ENABLE_V1 to eth1's register NvRegTxPauseFrame
- write NVREG_MISC1_PAUSE_TX | NVREG_MISC1_FORCE to eth1's register NvRegMisc1
- write 0 to eth1's register NvRegTransmitterControl
This is what this patch avoids.
Signed-off-by: David Decotigny <decot@googlers.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
1 file changed