x86: devicetree: Configure IOAPIC pin only once
We use io_apic_setup_irq_pin() in order to configure pin's interrupt
number polarity and type. This is done on every irq_create_of_mapping()
which happens for instance during pci enable calls. Level typed
interrupts are masked by default, edge are unmasked.
On the first ->xlate() call the level interrupt is configured and
masked. The driver calls request_irq() and the line is unmasked. Lets
assume the interrupt line is shared with another device and we call
pci_enable_device() for this device. The ->xlate() configures the pin
again and it is masked. request_irq() does not unmask the line because
it _is_ already unmasked according to its internal state. So the
interrupt will never be unmasked again.
This patch is based on an earlier work by Torben Hohn and solves the
problem by configuring the pin only once. Since all devices must agree
on the same type and polarity there is no point in configuring the pin
more than once.
[ tglx: Split out the ce4100 part into a separate patch ]
Cc: Torben Hohn <torbenh@linutronix.de>
Signed-off-by: Sebastian Andrzej Siewior <bigeasy@linutronix.de>
Link: http://lkml.kernel.org/r/%3C20110427143052.GA15211%40linutronix.de%3E
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
diff --git a/arch/x86/include/asm/io_apic.h b/arch/x86/include/asm/io_apic.h
index c4bd267..a97a240 100644
--- a/arch/x86/include/asm/io_apic.h
+++ b/arch/x86/include/asm/io_apic.h
@@ -150,7 +150,7 @@
extern void ioapic_and_gsi_init(void);
extern void ioapic_insert_resources(void);
-int io_apic_setup_irq_pin(unsigned int irq, int node, struct io_apic_irq_attr *attr);
+int io_apic_setup_irq_pin_once(unsigned int irq, int node, struct io_apic_irq_attr *attr);
extern struct IO_APIC_route_entry **alloc_ioapic_entries(void);
extern void free_ioapic_entries(struct IO_APIC_route_entry **ioapic_entries);