ARM: mach-shmobile: mackerel: clarify shdi/mmcif switch settings
* Pins 2 and 4 of switch 33 are documented as don't care on the PCB,
my testing seems to confirm this.
* I have been unable to do anything sensible with S1 set to on.
Am I missing something with regards to MMC1?
* Clarify which driver is needed for each switch setting.
* Should the AP4 board code be updated to allow the
SHDI driver to access SHDI1 as the mackerel code does?
Signed-off-by: Simon Horman <horms@verge.net.au>
Acked-by: Yusuke Goda <yusuke.goda.sx@renesas.com>
Signed-off-by: Paul Mundt <lethal@linux-sh.org>
diff --git a/arch/arm/mach-shmobile/board-mackerel.c b/arch/arm/mach-shmobile/board-mackerel.c
index 7b15d21..fb4213a 100644
--- a/arch/arm/mach-shmobile/board-mackerel.c
+++ b/arch/arm/mach-shmobile/board-mackerel.c
@@ -169,9 +169,8 @@
* SW1 | SW33
* | bit1 | bit2 | bit3 | bit4
* -------------+------+------+------+-------
- * MMC0 OFF | OFF | ON | ON | X
- * MMC1 ON | OFF | ON | X | ON
- * SDHI1 OFF | ON | X | OFF | ON
+ * MMC0 OFF | OFF | X | ON | X (Use MMCIF)
+ * SDHI1 OFF | ON | X | OFF | X (Use MFD_SH_MOBILE_SDHI)
*
*/