phy: Centralise print about attached phy
Many Ethernet drivers contain the same netdev_info() print statement
about the attached phy. Move it into the phy device code. Additionally
add a varargs function which can be used to append additional
information.
Signed-off-by: Andrew Lunn <andrew@lunn.ch>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/synopsys/dwc_eth_qos.c b/drivers/net/ethernet/synopsys/dwc_eth_qos.c
index 9066d7a..b25ee37 100644
--- a/drivers/net/ethernet/synopsys/dwc_eth_qos.c
+++ b/drivers/net/ethernet/synopsys/dwc_eth_qos.c
@@ -972,9 +972,7 @@
}
if (netif_msg_probe(lp))
- netdev_dbg(lp->ndev,
- "phydev %p, phydev->phy_id 0xa%x, phydev->addr 0x%x\n",
- phydev, phydev->phy_id, phydev->addr);
+ phy_attached_info(phydev);
phydev->supported &= PHY_GBIT_FEATURES;
@@ -983,14 +981,6 @@
lp->duplex = DUPLEX_UNKNOWN;
lp->phy_dev = phydev;
- if (netif_msg_probe(lp)) {
- netdev_dbg(lp->ndev, "phy_addr 0x%x, phy_id 0x%08x\n",
- lp->phy_dev->addr, lp->phy_dev->phy_id);
-
- netdev_dbg(lp->ndev, "attach [%s] phy driver\n",
- lp->phy_dev->drv->name);
- }
-
return 0;
}