usb: gadget: atmel_usba_udc: Fixed vbus_prev initial state
If vbus gpio is high at init, we should set vbus_prev to true
accordingly to the current vbus state. Without that, we skip the first
vbus interrupt because the saved vbus state is not consistent.
Signed-off-by: Sylvain Rochet <sylvain.rochet@finsecur.com>
Acked-by: Nicolas Ferre <nicolas.ferre@atmel.com>
Acked-by: Boris Brezillon <boris.brezillon@free-electrons.com>
Signed-off-by: Felipe Balbi <balbi@ti.com>
diff --git a/drivers/usb/gadget/udc/atmel_usba_udc.c b/drivers/usb/gadget/udc/atmel_usba_udc.c
index d79cb35..e63c6fc 100644
--- a/drivers/usb/gadget/udc/atmel_usba_udc.c
+++ b/drivers/usb/gadget/udc/atmel_usba_udc.c
@@ -1811,6 +1811,8 @@
toggle_bias(udc, 1);
usba_writel(udc, CTRL, USBA_ENABLE_MASK);
usba_int_enb_set(udc, USBA_END_OF_RESET);
+
+ udc->vbus_prev = 1;
}
spin_unlock_irqrestore(&udc->lock, flags);