[POWERPC] cell: update Cell BE register definitions
There are a few definitions that are required by subsequent patches,
so add them here.
The original patch is from David Erb, but is significantly cleaned
up by Kevon Corry.
Cc: Kevin Corry <kevcorry@us.ibm.com>
Signed-off-by: Arnd Bergmann <arnd.bergmann@de.ibm.com>
Signed-off-by: Paul Mackerras <paulus@samba.org>
diff --git a/arch/powerpc/platforms/cell/cbe_regs.h b/arch/powerpc/platforms/cell/cbe_regs.h
index e76e4a6..02bdbc1 100644
--- a/arch/powerpc/platforms/cell/cbe_regs.h
+++ b/arch/powerpc/platforms/cell/cbe_regs.h
@@ -4,6 +4,11 @@
* This file is intended to hold the various register definitions for CBE
* on-chip system devices (memory controller, IO controller, etc...)
*
+ * (C) Copyright IBM Corporation 2001,2006
+ *
+ * Authors: Maximino Aguilar (maguilar@us.ibm.com)
+ * David J. Erb (djerb@us.ibm.com)
+ *
* (c) 2006 Benjamin Herrenschmidt <benh@kernel.crashing.org>, IBM Corp.
*/
@@ -22,6 +27,7 @@
#define HID0_CBE_THERM_INT_EN 0x0000000400000000ul
#define HID0_CBE_SYSERR_INT_EN 0x0000000200000000ul
+#define MAX_CBE 2
/*
*
@@ -29,45 +35,86 @@
*
*/
+union spe_reg {
+ u64 val;
+ u8 spe[8];
+};
+
+union ppe_spe_reg {
+ u64 val;
+ struct {
+ u32 ppe;
+ u32 spe;
+ };
+};
+
+
struct cbe_pmd_regs {
- u8 pad_0x0000_0x0800[0x0800 - 0x0000]; /* 0x0000 */
+ /* Debug Bus Control */
+ u64 pad_0x0000; /* 0x0000 */
+
+ u64 group_control; /* 0x0008 */
+
+ u8 pad_0x0010_0x00a8 [0x00a8 - 0x0010]; /* 0x0010 */
+
+ u64 debug_bus_control; /* 0x00a8 */
+
+ u8 pad_0x00b0_0x0100 [0x0100 - 0x00b0]; /* 0x00b0 */
+
+ u64 trace_aux_data; /* 0x0100 */
+ u64 trace_buffer_0_63; /* 0x0108 */
+ u64 trace_buffer_64_127; /* 0x0110 */
+ u64 trace_address; /* 0x0118 */
+ u64 ext_tr_timer; /* 0x0120 */
+
+ u8 pad_0x0128_0x0400 [0x0400 - 0x0128]; /* 0x0128 */
+
+ /* Performance Monitor */
+ u64 pm_status; /* 0x0400 */
+ u64 pm_control; /* 0x0408 */
+ u64 pm_interval; /* 0x0410 */
+ u64 pm_ctr[4]; /* 0x0418 */
+ u64 pm_start_stop; /* 0x0438 */
+ u64 pm07_control[8]; /* 0x0440 */
+
+ u8 pad_0x0480_0x0800 [0x0800 - 0x0480]; /* 0x0480 */
/* Thermal Sensor Registers */
- u64 ts_ctsr1; /* 0x0800 */
- u64 ts_ctsr2; /* 0x0808 */
- u64 ts_mtsr1; /* 0x0810 */
- u64 ts_mtsr2; /* 0x0818 */
- u64 ts_itr1; /* 0x0820 */
- u64 ts_itr2; /* 0x0828 */
- u64 ts_gitr; /* 0x0830 */
- u64 ts_isr; /* 0x0838 */
- u64 ts_imr; /* 0x0840 */
- u64 tm_cr1; /* 0x0848 */
- u64 tm_cr2; /* 0x0850 */
- u64 tm_simr; /* 0x0858 */
- u64 tm_tpr; /* 0x0860 */
- u64 tm_str1; /* 0x0868 */
- u64 tm_str2; /* 0x0870 */
- u64 tm_tsr; /* 0x0878 */
+ union spe_reg ts_ctsr1; /* 0x0800 */
+ u64 ts_ctsr2; /* 0x0808 */
+ union spe_reg ts_mtsr1; /* 0x0810 */
+ u64 ts_mtsr2; /* 0x0818 */
+ union spe_reg ts_itr1; /* 0x0820 */
+ u64 ts_itr2; /* 0x0828 */
+ u64 ts_gitr; /* 0x0830 */
+ u64 ts_isr; /* 0x0838 */
+ u64 ts_imr; /* 0x0840 */
+ union spe_reg tm_cr1; /* 0x0848 */
+ u64 tm_cr2; /* 0x0850 */
+ u64 tm_simr; /* 0x0858 */
+ union ppe_spe_reg tm_tpr; /* 0x0860 */
+ union spe_reg tm_str1; /* 0x0868 */
+ u64 tm_str2; /* 0x0870 */
+ union ppe_spe_reg tm_tsr; /* 0x0878 */
/* Power Management */
- u64 pm_control; /* 0x0880 */
-#define CBE_PMD_PAUSE_ZERO_CONTROL 0x10000
- u64 pm_status; /* 0x0888 */
+ u64 pmcr; /* 0x0880 */
+#define CBE_PMD_PAUSE_ZERO_CONTROL 0x10000
+ u64 pmsr; /* 0x0888 */
/* Time Base Register */
- u64 tbr; /* 0x0890 */
+ u64 tbr; /* 0x0890 */
- u8 pad_0x0898_0x0c00 [0x0c00 - 0x0898]; /* 0x0898 */
+ u8 pad_0x0898_0x0c00 [0x0c00 - 0x0898]; /* 0x0898 */
/* Fault Isolation Registers */
- u64 checkstop_fir; /* 0x0c00 */
- u64 recoverable_fir;
- u64 spec_att_mchk_fir;
- u64 fir_mode_reg;
- u64 fir_enable_mask;
+ u64 checkstop_fir; /* 0x0c00 */
+ u64 recoverable_fir; /* 0x0c08 */
+ u64 spec_att_mchk_fir; /* 0x0c10 */
+ u64 fir_mode_reg; /* 0x0c18 */
+ u64 fir_enable_mask; /* 0x0c20 */
- u8 pad_0x0c28_0x1000 [0x1000 - 0x0c28]; /* 0x0c28 */
+ u8 pad_0x0c28_0x1000 [0x1000 - 0x0c28]; /* 0x0c28 */
};
extern struct cbe_pmd_regs __iomem *cbe_get_pmd_regs(struct device_node *np);
@@ -102,18 +149,20 @@
/* IIC interrupt registers */
struct cbe_iic_thread_regs thread[2]; /* 0x0400 */
- u64 iic_ir; /* 0x0440 */
- u64 iic_is; /* 0x0448 */
+
+ u64 iic_ir; /* 0x0440 */
+ u64 iic_is; /* 0x0448 */
+#define CBE_IIC_IS_PMI 0x2
u8 pad_0x0450_0x0500[0x0500 - 0x0450]; /* 0x0450 */
/* IOC FIR */
u64 ioc_fir_reset; /* 0x0500 */
- u64 ioc_fir_set;
- u64 ioc_checkstop_enable;
- u64 ioc_fir_error_mask;
- u64 ioc_syserr_enable;
- u64 ioc_fir;
+ u64 ioc_fir_set; /* 0x0508 */
+ u64 ioc_checkstop_enable; /* 0x0510 */
+ u64 ioc_fir_error_mask; /* 0x0518 */
+ u64 ioc_syserr_enable; /* 0x0520 */
+ u64 ioc_fir; /* 0x0528 */
u8 pad_0x0530_0x1000[0x1000 - 0x0530]; /* 0x0530 */
};
@@ -122,6 +171,48 @@
extern struct cbe_iic_regs __iomem *cbe_get_cpu_iic_regs(int cpu);
+struct cbe_mic_tm_regs {
+ u8 pad_0x0000_0x0040[0x0040 - 0x0000]; /* 0x0000 */
+
+ u64 mic_ctl_cnfg2; /* 0x0040 */
+#define CBE_MIC_ENABLE_AUX_TRC 0x8000000000000000LL
+#define CBE_MIC_DISABLE_PWR_SAV_2 0x0200000000000000LL
+#define CBE_MIC_DISABLE_AUX_TRC_WRAP 0x0100000000000000LL
+#define CBE_MIC_ENABLE_AUX_TRC_INT 0x0080000000000000LL
+
+ u64 pad_0x0048; /* 0x0048 */
+
+ u64 mic_aux_trc_base; /* 0x0050 */
+ u64 mic_aux_trc_max_addr; /* 0x0058 */
+ u64 mic_aux_trc_cur_addr; /* 0x0060 */
+ u64 mic_aux_trc_grf_addr; /* 0x0068 */
+ u64 mic_aux_trc_grf_data; /* 0x0070 */
+
+ u64 pad_0x0078; /* 0x0078 */
+
+ u64 mic_ctl_cnfg_0; /* 0x0080 */
+#define CBE_MIC_DISABLE_PWR_SAV_0 0x8000000000000000LL
+
+ u64 pad_0x0088; /* 0x0088 */
+
+ u64 slow_fast_timer_0; /* 0x0090 */
+ u64 slow_next_timer_0; /* 0x0098 */
+
+ u8 pad_0x00a0_0x01c0[0x01c0 - 0x0a0]; /* 0x00a0 */
+
+ u64 mic_ctl_cnfg_1; /* 0x01c0 */
+#define CBE_MIC_DISABLE_PWR_SAV_1 0x8000000000000000LL
+ u64 pad_0x01c8; /* 0x01c8 */
+
+ u64 slow_fast_timer_1; /* 0x01d0 */
+ u64 slow_next_timer_1; /* 0x01d8 */
+
+ u8 pad_0x01e0_0x1000[0x1000 - 0x01e0]; /* 0x01e0 */
+};
+
+extern struct cbe_mic_tm_regs __iomem *cbe_get_mic_tm_regs(struct device_node *np);
+extern struct cbe_mic_tm_regs __iomem *cbe_get_cpu_mic_tm_regs(int cpu);
+
/* Init this module early */
extern void cbe_regs_init(void);