mac80211: 802.11p OCB mode support
This patch adds 802.11p OCB (Outside the Context of a BSS) mode
support.
When communicating in OCB mode a mandatory wildcard BSSID
(48 '1' bits) is used.
The EDCA parameters handling function was changed to support
802.11p specific values.
The insertion of a newly discovered STAs is done in the similar way
as in the IBSS mode -- through the deferred insertion.
The OCB mode uses a periodic 'housekeeping task' for expiration of
disconnected STAs (in the similar manner as in the MESH mode).
New Kconfig option for verbose OCB debugging outputs is added.
Signed-off-by: Rostislav Lisovy <rostislav.lisovy@fel.cvut.cz>
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
diff --git a/net/mac80211/cfg.c b/net/mac80211/cfg.c
index 1e2afc9..0618594 100644
--- a/net/mac80211/cfg.c
+++ b/net/mac80211/cfg.c
@@ -2019,6 +2019,17 @@
return ieee80211_ibss_leave(IEEE80211_DEV_TO_SUB_IF(dev));
}
+static int ieee80211_join_ocb(struct wiphy *wiphy, struct net_device *dev,
+ struct ocb_setup *setup)
+{
+ return ieee80211_ocb_join(IEEE80211_DEV_TO_SUB_IF(dev), setup);
+}
+
+static int ieee80211_leave_ocb(struct wiphy *wiphy, struct net_device *dev)
+{
+ return ieee80211_ocb_leave(IEEE80211_DEV_TO_SUB_IF(dev));
+}
+
static int ieee80211_set_mcast_rate(struct wiphy *wiphy, struct net_device *dev,
int rate[IEEE80211_NUM_BANDS])
{
@@ -3693,6 +3704,8 @@
.join_mesh = ieee80211_join_mesh,
.leave_mesh = ieee80211_leave_mesh,
#endif
+ .join_ocb = ieee80211_join_ocb,
+ .leave_ocb = ieee80211_leave_ocb,
.change_bss = ieee80211_change_bss,
.set_txq_params = ieee80211_set_txq_params,
.set_monitor_channel = ieee80211_set_monitor_channel,