diff --git a/arch/mips/cavium-octeon/executive/cvmx-helper-board.c b/arch/mips/cavium-octeon/executive/cvmx-helper-board.c
index ff49fc0..3751c58 100644
--- a/arch/mips/cavium-octeon/executive/cvmx-helper-board.c
+++ b/arch/mips/cavium-octeon/executive/cvmx-helper-board.c
@@ -676,48 +676,6 @@
 				       0xc);
 		}
 	} else if (cvmx_sysinfo_get()->board_type ==
-		   CVMX_BOARD_TYPE_CN3010_EVB_HS5) {
-		/*
-		 * Broadcom PHYs require differnet ASX
-		 * clocks. Unfortunately many boards don't define a
-		 * new board Id and simply mangle the
-		 * CN3010_EVB_HS5
-		 */
-		if (interface == 0) {
-			/*
-			 * Some boards use a hacked up bootloader that
-			 * identifies them as CN3010_EVB_HS5
-			 * evaluation boards.  This leads to all kinds
-			 * of configuration problems.  Detect one
-			 * case, and print warning, while trying to do
-			 * the right thing.
-			 */
-			int phy_addr = cvmx_helper_board_get_mii_address(0);
-			if (phy_addr != -1) {
-				int phy_identifier =
-				    cvmx_mdio_read(phy_addr >> 8,
-						   phy_addr & 0xff, 0x2);
-				/* Is it a Broadcom PHY? */
-				if (phy_identifier == 0x0143) {
-					cvmx_dprintf("\n");
-					cvmx_dprintf("ERROR:\n");
-					cvmx_dprintf
-					    ("ERROR: Board type is CVMX_BOARD_TYPE_CN3010_EVB_HS5, but Broadcom PHY found.\n");
-					cvmx_dprintf
-					    ("ERROR: The board type is mis-configured, and software malfunctions are likely.\n");
-					cvmx_dprintf
-					    ("ERROR: All boards require a unique board type to identify them.\n");
-					cvmx_dprintf("ERROR:\n");
-					cvmx_dprintf("\n");
-					cvmx_wait(1000000000);
-					cvmx_write_csr(CVMX_ASXX_RX_CLK_SETX
-						       (0, interface), 5);
-					cvmx_write_csr(CVMX_ASXX_TX_CLK_SETX
-						       (0, interface), 5);
-				}
-			}
-		}
-	} else if (cvmx_sysinfo_get()->board_type ==
 			CVMX_BOARD_TYPE_UBNT_E100) {
 		cvmx_write_csr(CVMX_ASXX_RX_CLK_SETX(0, interface), 0);
 		cvmx_write_csr(CVMX_ASXX_TX_CLK_SETX(0, interface), 0x10);