libata: add another IRQ calls (libata drivers)
This patch is against each libata driver.
Two IRQ calls are added in ata_port_operations.
- irq_on() is used to enable interrupts.
- irq_ack() is used to acknowledge a device interrupt.
In most drivers, ata_irq_on() and ata_irq_ack() are used for
irq_on and irq_ack respectively.
In some drivers (ex: ahci, sata_sil24) which cannot use them
as is, ata_dummy_irq_on() and ata_dummy_irq_ack() are used.
Signed-off-by: Kou Ishizaki <kou.ishizaki@toshiba.co.jp>
Signed-off-by: Akira Iguchi <akira2.iguchi@toshiba.co.jp>
Signed-off-by: Jeff Garzik <jeff@garzik.org>
diff --git a/drivers/ata/ahci.c b/drivers/ata/ahci.c
index 6d66484..92cdb0c 100644
--- a/drivers/ata/ahci.c
+++ b/drivers/ata/ahci.c
@@ -260,6 +260,8 @@
.irq_handler = ahci_interrupt,
.irq_clear = ahci_irq_clear,
+ .irq_on = ata_dummy_irq_on,
+ .irq_ack = ata_dummy_irq_ack,
.scr_read = ahci_scr_read,
.scr_write = ahci_scr_write,
@@ -291,6 +293,8 @@
.irq_handler = ahci_interrupt,
.irq_clear = ahci_irq_clear,
+ .irq_on = ata_dummy_irq_on,
+ .irq_ack = ata_dummy_irq_ack,
.scr_read = ahci_scr_read,
.scr_write = ahci_scr_write,