pinctrl: qcom-spmi-gpio: Fix input value report
Read input buffer when input is enabled, not when it is
disabled. Also fix interpretation of the pmic_gpio_read()
return code, negative value means an error.
Signed-off-by: Ivan T. Ivanov <ivan.ivanov@linaro.org>
Reviewed-by: Bjorn Andersson <bjorn.andersson@sonymobile.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
diff --git a/drivers/pinctrl/qcom/pinctrl-spmi-gpio.c b/drivers/pinctrl/qcom/pinctrl-spmi-gpio.c
index 4b21aac..e8b74c6 100644
--- a/drivers/pinctrl/qcom/pinctrl-spmi-gpio.c
+++ b/drivers/pinctrl/qcom/pinctrl-spmi-gpio.c
@@ -466,12 +466,13 @@
seq_puts(s, " ---");
} else {
- if (!pad->input_enabled) {
+ if (pad->input_enabled) {
ret = pmic_gpio_read(state, pad, PMIC_MPP_REG_RT_STS);
- if (!ret) {
- ret &= PMIC_MPP_REG_RT_STS_VAL_MASK;
- pad->out_value = ret;
- }
+ if (ret < 0)
+ return;
+
+ ret &= PMIC_MPP_REG_RT_STS_VAL_MASK;
+ pad->out_value = ret;
}
seq_printf(s, " %-4s", pad->output_enabled ? "out" : "in");