[SCSI] qla2xxx: Correct ISP abort semantics for NVRAM, VPD, and flash update.
Ensure that an ISP-abort has completed before performing any
update. After the update do not wait for an ISP-abort completion,
instead just wait until the ISP is reset. This avoids long
delays due to waiting for loop ready in qla2x00_abort_isp().
Signed-off-by: Lalit Chandivade <lalit.chandivade@qlogic.com>
Additional cleanups and
Signed-off-by: Andrew Vasquez <andrew.vasquez@qlogic.com>
Signed-off-by: James Bottomley <James.Bottomley@HansenPartnership.com>
diff --git a/drivers/scsi/qla2xxx/qla_os.c b/drivers/scsi/qla2xxx/qla_os.c
index c795461..1c3d165 100644
--- a/drivers/scsi/qla2xxx/qla_os.c
+++ b/drivers/scsi/qla2xxx/qla_os.c
@@ -535,6 +535,34 @@
return (return_status);
}
+int
+qla2x00_wait_for_chip_reset(scsi_qla_host_t *vha)
+{
+ int return_status;
+ unsigned long wait_reset;
+ struct qla_hw_data *ha = vha->hw;
+ scsi_qla_host_t *base_vha = pci_get_drvdata(ha->pdev);
+
+ wait_reset = jiffies + (MAX_LOOP_TIMEOUT * HZ);
+ while (((test_bit(ISP_ABORT_NEEDED, &base_vha->dpc_flags)) ||
+ test_bit(ABORT_ISP_ACTIVE, &base_vha->dpc_flags) ||
+ test_bit(ISP_ABORT_RETRY, &base_vha->dpc_flags) ||
+ ha->dpc_active) && time_before(jiffies, wait_reset)) {
+
+ msleep(1000);
+
+ if (!test_bit(ISP_ABORT_NEEDED, &base_vha->dpc_flags) &&
+ ha->flags.chip_reset_done)
+ break;
+ }
+ if (ha->flags.chip_reset_done)
+ return_status = QLA_SUCCESS;
+ else
+ return_status = QLA_FUNCTION_FAILED;
+
+ return return_status;
+}
+
/*
* qla2x00_wait_for_loop_ready
* Wait for MAX_LOOP_TIMEOUT(5 min) value for loop