ethtool: Use full 32 bit speed range in ethtool's set_settings
This makes sure the ethtool's set_settings() callback of network
drivers don't ignore the 16 most significant bits when ethtool calls
their set_settings().
All drivers compiled with make allyesconfig on x86_64 have been
updated.
Signed-off-by: David Decotigny <decot@google.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/mii.c b/drivers/net/mii.c
index 05acca7..e8198ed 100644
--- a/drivers/net/mii.c
+++ b/drivers/net/mii.c
@@ -157,10 +157,11 @@
int mii_ethtool_sset(struct mii_if_info *mii, struct ethtool_cmd *ecmd)
{
struct net_device *dev = mii->dev;
+ u32 speed = ethtool_cmd_speed(ecmd);
- if (ecmd->speed != SPEED_10 &&
- ecmd->speed != SPEED_100 &&
- ecmd->speed != SPEED_1000)
+ if (speed != SPEED_10 &&
+ speed != SPEED_100 &&
+ speed != SPEED_1000)
return -EINVAL;
if (ecmd->duplex != DUPLEX_HALF && ecmd->duplex != DUPLEX_FULL)
return -EINVAL;
@@ -172,7 +173,7 @@
return -EINVAL;
if (ecmd->autoneg != AUTONEG_DISABLE && ecmd->autoneg != AUTONEG_ENABLE)
return -EINVAL;
- if ((ecmd->speed == SPEED_1000) && (!mii->supports_gmii))
+ if ((speed == SPEED_1000) && (!mii->supports_gmii))
return -EINVAL;
/* ignore supported, maxtxpkt, maxrxpkt */
@@ -230,9 +231,9 @@
bmcr = mii->mdio_read(dev, mii->phy_id, MII_BMCR);
tmp = bmcr & ~(BMCR_ANENABLE | BMCR_SPEED100 |
BMCR_SPEED1000 | BMCR_FULLDPLX);
- if (ecmd->speed == SPEED_1000)
+ if (speed == SPEED_1000)
tmp |= BMCR_SPEED1000;
- else if (ecmd->speed == SPEED_100)
+ else if (speed == SPEED_100)
tmp |= BMCR_SPEED100;
if (ecmd->duplex == DUPLEX_FULL) {
tmp |= BMCR_FULLDPLX;