8250: use the 8250 register interface not the legacy one
The old interface just copies bits over and calls the newer one.
In addition we can now pass more information.
Signed-off-by: Alan Cox <alan@linux.intel.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
diff --git a/drivers/tty/serial/8250/8250_hp300.c b/drivers/tty/serial/8250/8250_hp300.c
index c13438c..8f1dd2c 100644
--- a/drivers/tty/serial/8250/8250_hp300.c
+++ b/drivers/tty/serial/8250/8250_hp300.c
@@ -171,7 +171,7 @@
return 0;
}
#endif
- memset(&port, 0, sizeof(struct uart_port));
+ memset(&uart, 0, sizeof(uart));
/* Memory mapped I/O */
port.iotype = UPIO_MEM;
@@ -182,7 +182,7 @@
port.membase = (char *)(port.mapbase + DIO_VIRADDRBASE);
port.regshift = 1;
port.dev = &d->dev;
- line = serial8250_register_port(&port);
+ line = serial8250_register_8250_port(&uart);
if (line < 0) {
printk(KERN_NOTICE "8250_hp300: register_serial() DCA scode %d"
@@ -210,7 +210,7 @@
#ifdef CONFIG_HPAPCI
int line;
unsigned long base;
- struct uart_port uport;
+ struct uart_8250_port uart;
struct hp300_port *port;
int i;
#endif
@@ -248,26 +248,26 @@
if (!port)
return -ENOMEM;
- memset(&uport, 0, sizeof(struct uart_port));
+ memset(&uart, 0, sizeof(uart));
base = (FRODO_BASE + FRODO_APCI_OFFSET(i));
/* Memory mapped I/O */
- uport.iotype = UPIO_MEM;
- uport.flags = UPF_SKIP_TEST | UPF_SHARE_IRQ \
+ uart.port.iotype = UPIO_MEM;
+ uart.port.flags = UPF_SKIP_TEST | UPF_SHARE_IRQ \
| UPF_BOOT_AUTOCONF;
/* XXX - no interrupt support yet */
- uport.irq = 0;
- uport.uartclk = HPAPCI_BAUD_BASE * 16;
- uport.mapbase = base;
- uport.membase = (char *)(base + DIO_VIRADDRBASE);
- uport.regshift = 2;
+ uart.port.irq = 0;
+ uart.port.uartclk = HPAPCI_BAUD_BASE * 16;
+ uart.port.mapbase = base;
+ uart.port.membase = (char *)(base + DIO_VIRADDRBASE);
+ uart.port.regshift = 2;
- line = serial8250_register_port(&uport);
+ line = serial8250_register_8250_port(&uart);
if (line < 0) {
printk(KERN_NOTICE "8250_hp300: register_serial() APCI"
- " %d irq %d failed\n", i, uport.irq);
+ " %d irq %d failed\n", i, uart.port.irq);
kfree(port);
continue;
}