iwlwifi: mvm: don't enable VHT MCS9 in 20Mhz
MCS9 in NSS=1 or NSS=2 isn't valid for 20Mhz so don't enable
it in case we're dealing with a 20Mhz sta. Trying to configure an
MCS9 rate with 20Mhz in the LQ rate table would lead to a FW assert.
Signed-off-by: Eyal Shapira <eyal@wizery.com>
Reviewed-by: Johannes Berg <johannes.berg@intel.com>
Signed-off-by: Emmanuel Grumbach <emmanuel.grumbach@intel.com>
diff --git a/drivers/net/wireless/iwlwifi/mvm/rs.c b/drivers/net/wireless/iwlwifi/mvm/rs.c
index 9565260..f1364b7 100644
--- a/drivers/net/wireless/iwlwifi/mvm/rs.c
+++ b/drivers/net/wireless/iwlwifi/mvm/rs.c
@@ -2241,6 +2241,11 @@
if (i == IWL_RATE_9M_INDEX)
continue;
+ /* VHT MCS9 isn't valid for 20Mhz for NSS=1,2 */
+ if (i == IWL_RATE_MCS_9_INDEX &&
+ sta->bandwidth == IEEE80211_STA_RX_BW_20)
+ continue;
+
lq_sta->active_siso_rate |= BIT(i);
}
}
@@ -2251,6 +2256,11 @@
if (i == IWL_RATE_9M_INDEX)
continue;
+ /* VHT MCS9 isn't valid for 20Mhz for NSS=1,2 */
+ if (i == IWL_RATE_MCS_9_INDEX &&
+ sta->bandwidth == IEEE80211_STA_RX_BW_20)
+ continue;
+
lq_sta->active_mimo2_rate |= BIT(i);
}
}