KVM: s390: hardware support for guest debugging
This patch adds support to debug the guest using the PER facility on s390.
Single-stepping, hardware breakpoints and hardware watchpoints are supported. In
order to use the PER facility of the guest without it noticing it, the control
registers of the guest have to be patched and access to them has to be
intercepted(stctl, stctg, lctl, lctlg).
All PER program interrupts have to be intercepted and only the relevant PER
interrupts for the guest have to be given back. Special care has to be taken
about repeated exits on the same hardware breakpoint. The intervention of the
host in the guests PER configuration is not fully transparent. PER instruction
nullification can not be used by the guest and too many storage alteration
events may be reported to the guest (if it is activated for special address
ranges only) when the host concurrently debugging it.
Signed-off-by: David Hildenbrand <dahi@linux.vnet.ibm.com>
Signed-off-by: Christian Borntraeger <borntraeger@de.ibm.com>
diff --git a/arch/s390/kvm/Makefile b/arch/s390/kvm/Makefile
index 83a7a35..b3b5534 100644
--- a/arch/s390/kvm/Makefile
+++ b/arch/s390/kvm/Makefile
@@ -12,6 +12,6 @@
ccflags-y := -Ivirt/kvm -Iarch/s390/kvm
kvm-objs := $(common-objs) kvm-s390.o intercept.o interrupt.o priv.o sigp.o
-kvm-objs += diag.o gaccess.o
+kvm-objs += diag.o gaccess.o guestdbg.o
obj-$(CONFIG_KVM) += kvm.o