[SCSI] qla2xxx: Add NPIV-Config Table support.
To instatiate pre-configured vport entities defined within an
HBA's flash memory.
Signed-off-by: Andrew Vasquez <andrew.vasquez@qlogic.com>
Signed-off-by: James Bottomley <James.Bottomley@HansenPartnership.com>
diff --git a/drivers/scsi/qla2xxx/qla_os.c b/drivers/scsi/qla2xxx/qla_os.c
index c1ffc30..3433441 100644
--- a/drivers/scsi/qla2xxx/qla_os.c
+++ b/drivers/scsi/qla2xxx/qla_os.c
@@ -1517,6 +1517,7 @@
set_bit(LOOP_RESYNC_NEEDED, &ha->dpc_flags);
set_bit(LOCAL_LOOP_UPDATE, &ha->dpc_flags);
set_bit(RSCN_UPDATE, &ha->dpc_flags);
+ set_bit(NPIV_CONFIG_NEEDED, &ha->dpc_flags);
}
static int
@@ -2431,6 +2432,12 @@
ha->host_no));
}
+ if (test_bit(NPIV_CONFIG_NEEDED, &ha->dpc_flags) &&
+ atomic_read(&ha->loop_state) == LOOP_READY) {
+ clear_bit(NPIV_CONFIG_NEEDED, &ha->dpc_flags);
+ qla2xxx_flash_npiv_conf(ha);
+ }
+
if (!ha->interrupts_on)
ha->isp_ops->enable_intrs(ha);