clk: Show correct information when fail to set clock rate
This patch shows the correct information for debugging when fail
to set clock rate because original error message shows the error
value instead of current clock rate.
Cc: Mike Turquette <mturquette@linaro.org>
Signed-off-by: Chanwoo Choi <cw00.choi@samsung.com>
Acked-by: Sylwester Nawrocki <s.nawrocki@samsung.com>
Signed-off-by: Stephen Boyd <sboyd@codeaurora.org>
diff --git a/drivers/clk/clk-conf.c b/drivers/clk/clk-conf.c
index 48a65b2..35a396b 100644
--- a/drivers/clk/clk-conf.c
+++ b/drivers/clk/clk-conf.c
@@ -106,8 +106,9 @@
rc = clk_set_rate(clk, rate);
if (rc < 0)
- pr_err("clk: couldn't set %s clock rate: %d\n",
- __clk_get_name(clk), rc);
+ pr_err("clk: couldn't set %s clk rate to %d (%d), current rate: %ld\n",
+ __clk_get_name(clk), rate, rc,
+ clk_get_rate(clk));
clk_put(clk);
}
index++;