ktest: Add option REBOOT_SUCCESS_LINE to stop waiting after a reboot
When ktest.pl reboots, it will usuall wait SLEEP_TIME seconds of idle
console before starting the next test. By setting the
REBOOT_SUCCESS_LINE, ktest will not wait SLEEP_TIME when it detects the
line while rebooting to a new kernel.
Signed-off-by: Steven Rostedt <rostedt@goodmis.org>
diff --git a/tools/testing/ktest/ktest.pl b/tools/testing/ktest/ktest.pl
index 74fb2ac..51ddaa5 100755
--- a/tools/testing/ktest/ktest.pl
+++ b/tools/testing/ktest/ktest.pl
@@ -117,6 +117,7 @@
my $booted_timeout;
my $detect_triplefault;
my $console;
+my $reboot_success_line;
my $success_line;
my $stop_after_success;
my $stop_after_failure;
@@ -612,6 +613,13 @@
sub reboot {
my ($time) = @_;
+ if (defined($time)) {
+ start_monitor;
+ # flush out current monitor
+ # May contain the reboot success line
+ wait_for_monitor 1;
+ }
+
# try to reboot normally
if (run_command $reboot) {
if (defined($powercycle_after_reboot)) {
@@ -624,8 +632,7 @@
}
if (defined($time)) {
- start_monitor;
- wait_for_monitor $time;
+ wait_for_monitor($time, $reboot_success_line);
end_monitor;
}
}
@@ -706,16 +713,29 @@
}
sub wait_for_monitor {
- my ($time) = @_;
+ my ($time, $stop) = @_;
+ my $full_line = "";
my $line;
+ my $booted = 0;
doprint "** Wait for monitor to settle down **\n";
# read the monitor and wait for the system to calm down
- do {
+ while (!$booted) {
$line = wait_for_input($monitor_fp, $time);
- print "$line" if (defined($line));
- } while (defined($line));
+ last if (!defined($line));
+ print "$line";
+ $full_line .= $line;
+
+ if (defined($stop) && $full_line =~ /$stop/) {
+ doprint "wait for monitor detected $stop\n";
+ $booted = 1;
+ }
+
+ if ($line =~ /\n/) {
+ $full_line = "";
+ }
+ }
print "** Monitor flushed **\n";
}
@@ -2836,6 +2856,7 @@
$console = set_test_option("CONSOLE", $i);
$detect_triplefault = set_test_option("DETECT_TRIPLE_FAULT", $i);
$success_line = set_test_option("SUCCESS_LINE", $i);
+ $reboot_success_line = set_test_option("REBOOT_SUCCESS_LINE", $i);
$stop_after_success = set_test_option("STOP_AFTER_SUCCESS", $i);
$stop_after_failure = set_test_option("STOP_AFTER_FAILURE", $i);
$stop_test_after = set_test_option("STOP_TEST_AFTER", $i);