ARM: Kirkwood: Convert DNSKW to use gpio-poweroff.
Also enable the gpio-poweroff driver when DT is used.
Signed-off-by: Andrew Lunn <andrew@lunn.ch>
Tested-by: Jamie Lentin <jm@lentin.co.uk>
Signed-off-by: Jason Cooper <jason@lakedaemon.net>
diff --git a/arch/arm/boot/dts/kirkwood-dnskw.dtsi b/arch/arm/boot/dts/kirkwood-dnskw.dtsi
index fd23e63..28263a1 100644
--- a/arch/arm/boot/dts/kirkwood-dnskw.dtsi
+++ b/arch/arm/boot/dts/kirkwood-dnskw.dtsi
@@ -35,6 +35,11 @@
6000 2>;
};
+ gpio_poweroff {
+ compatible = "gpio-poweroff";
+ gpios = <&gpio1 4 0>;
+ };
+
ocp@f1000000 {
sata@80000 {
status = "okay";
diff --git a/arch/arm/mach-kirkwood/Kconfig b/arch/arm/mach-kirkwood/Kconfig
index d018ad4..35b3258 100644
--- a/arch/arm/mach-kirkwood/Kconfig
+++ b/arch/arm/mach-kirkwood/Kconfig
@@ -46,6 +46,9 @@
config ARCH_KIRKWOOD_DT
bool "Marvell Kirkwood Flattened Device Tree"
+ select POWER_SUPPLY
+ select POWER_RESET
+ select POWER_RESET_GPIO
select USE_OF
help
Say 'Y' here if you want your kernel to support the
diff --git a/arch/arm/mach-kirkwood/board-dnskw.c b/arch/arm/mach-kirkwood/board-dnskw.c
index 2ac6c60..9036801 100644
--- a/arch/arm/mach-kirkwood/board-dnskw.c
+++ b/arch/arm/mach-kirkwood/board-dnskw.c
@@ -57,11 +57,6 @@
0
};
-static void dnskw_power_off(void)
-{
- gpio_set_value(36, 1);
-}
-
/* Register any GPIO for output and set the value */
static void __init dnskw_gpio_register(unsigned gpio, char *name, int def)
{
@@ -80,13 +75,6 @@
kirkwood_ge00_init(&dnskw_ge00_data);
- /* Register power-off GPIO. */
- if (gpio_request(36, "dnskw:power:off") == 0
- && gpio_direction_output(36, 0) == 0)
- pm_power_off = dnskw_power_off;
- else
- pr_err("dnskw: failed to configure power-off GPIO\n");
-
/* Ensure power is supplied to both HDDs */
dnskw_gpio_register(39, "dnskw:power:sata0", 1);
dnskw_gpio_register(40, "dnskw:power:sata1", 1);