check ATTR_SIZE contraints in inode_change_ok
Make sure we check the truncate constraints early on in ->setattr by adding
those checks to inode_change_ok. Also clean up and document inode_change_ok
to make this obvious.
As a fallout we don't have to call inode_newsize_ok from simple_setsize and
simplify it down to a truncate_setsize which doesn't return an error. This
simplifies a lot of setattr implementations and means we use truncate_setsize
almost everywhere. Get rid of fat_setsize now that it's trivial and mark
ext2_setsize static to make the calling convention obvious.
Keep the inode_newsize_ok in vmtruncate for now as all callers need an
audit for its removal anyway.
Note: setattr code in ecryptfs doesn't call inode_change_ok at all and
needs a deeper audit, but that is left for later.
Signed-off-by: Christoph Hellwig <hch@lst.de>
Signed-off-by: Al Viro <viro@zeniv.linux.org.uk>
diff --git a/fs/ufs/truncate.c b/fs/ufs/truncate.c
index 085e116..34d5cb1 100644
--- a/fs/ufs/truncate.c
+++ b/fs/ufs/truncate.c
@@ -500,11 +500,6 @@
return err;
}
-/*
- * TODO:
- * - truncate case should use proper ordering instead of using
- * simple_setsize
- */
int ufs_setattr(struct dentry *dentry, struct iattr *attr)
{
struct inode *inode = dentry->d_inode;
@@ -518,9 +513,9 @@
if (ia_valid & ATTR_SIZE && attr->ia_size != inode->i_size) {
loff_t old_i_size = inode->i_size;
- error = simple_setsize(inode, attr->ia_size);
- if (error)
- return error;
+ /* XXX(truncate): truncate_setsize should be called last */
+ truncate_setsize(inode, attr->ia_size);
+
error = ufs_truncate(inode, old_i_size);
if (error)
return error;