USB: Prepare for refactoring by adding extra udev checks.
The next patch will refactor the hub port code to rip out the recursive
call to hub_port_reset on a failed hot reset. In preparation for that,
make sure all code paths can deal with being called with a NULL udev.
The usb_device will not be valid if warm reset was issued because a port
transitioned to the Inactive or Compliance Mode on a device connect.
This patch should have no effect on current behavior.
Signed-off-by: Sarah Sharp <sarah.a.sharp@linux.intel.com>
Acked-by: Alan Stern <stern@rowland.harvard.edu>
diff --git a/drivers/usb/core/hub.c b/drivers/usb/core/hub.c
index 855bb0d..c3368f9 100644
--- a/drivers/usb/core/hub.c
+++ b/drivers/usb/core/hub.c
@@ -2584,6 +2584,9 @@
return -ENOTCONN;
if ((portstatus & USB_PORT_STAT_ENABLE)) {
+ if (!udev)
+ return 0;
+
if (hub_is_wusb(hub))
udev->speed = USB_SPEED_WIRELESS;
else if (hub_is_superspeed(hub->hdev))
@@ -2627,13 +2630,15 @@
struct usb_hcd *hcd;
/* TRSTRCY = 10 ms; plus some extra */
msleep(10 + 40);
- update_devnum(udev, 0);
- hcd = bus_to_hcd(udev->bus);
- /* The xHC may think the device is already reset,
- * so ignore the status.
- */
- if (hcd->driver->reset_device)
- hcd->driver->reset_device(hcd, udev);
+ if (udev) {
+ update_devnum(udev, 0);
+ hcd = bus_to_hcd(udev->bus);
+ /* The xHC may think the device is already
+ * reset, so ignore the status.
+ */
+ if (hcd->driver->reset_device)
+ hcd->driver->reset_device(hcd, udev);
+ }
}
/* FALL THROUGH */
case -ENOTCONN:
@@ -2647,7 +2652,7 @@
clear_port_feature(hub->hdev, port1,
USB_PORT_FEAT_C_PORT_LINK_STATE);
}
- if (!warm)
+ if (!warm && udev)
usb_set_device_state(udev, *status
? USB_STATE_NOTATTACHED
: USB_STATE_DEFAULT);