[netdrvr] Use dev_printk() when ethernet interface isn't available
For messages prior to register_netdev(), prefer dev_printk() because
that prints out both our driver name and our [PCI | whatever] bus id.
Updates: 8139{cp,too}, b44, bnx2, cassini, {eepro,epic}100, fealnx,
hamachi, ne2k-pci, ns83820, pci-skeleton, r8169.
Signed-off-by: Jeff Garzik <jeff@garzik.org>
diff --git a/drivers/net/fealnx.c b/drivers/net/fealnx.c
index aaf13665..d26140a 100644
--- a/drivers/net/fealnx.c
+++ b/drivers/net/fealnx.c
@@ -578,9 +578,9 @@
if (mii_status != 0xffff && mii_status != 0x0000) {
np->phys[phy_idx++] = phy;
- printk(KERN_INFO
- "%s: MII PHY found at address %d, status "
- "0x%4.4x.\n", dev->name, phy, mii_status);
+ dev_printk(KERN_INFO, &pdev->dev,
+ "MII PHY found at address %d, status "
+ "0x%4.4x.\n", phy, mii_status);
/* get phy type */
{
unsigned int data;
@@ -603,10 +603,10 @@
}
np->mii_cnt = phy_idx;
- if (phy_idx == 0) {
- printk(KERN_WARNING "%s: MII PHY not found -- this device may "
- "not operate correctly.\n", dev->name);
- }
+ if (phy_idx == 0)
+ dev_printk(KERN_WARNING, &pdev->dev,
+ "MII PHY not found -- this device may "
+ "not operate correctly.\n");
} else {
np->phys[0] = 32;
/* 89/6/23 add, (begin) */
@@ -632,7 +632,8 @@
np->mii.full_duplex = full_duplex[card_idx];
if (np->mii.full_duplex) {
- printk(KERN_INFO "%s: Media type forced to Full Duplex.\n", dev->name);
+ dev_printk(KERN_INFO, &pdev->dev,
+ "Media type forced to Full Duplex.\n");
/* 89/6/13 add, (begin) */
// if (np->PHYType==MarvellPHY)
if ((np->PHYType == MarvellPHY) || (np->PHYType == LevelOnePHY)) {