drm/i915/crt: explicitly set up HOTPLUG_BITS on resume
... instead of relying on the register save/restore madness to do this.
To extract a bit of code call drm_mode_config_reset both on resume
and boot-up and move the hw state frobbing from the crt_init to the
->reset callback. The crt connector is the only one with a ->reset
callback, hence we can easily do this.
Reviewed-by: Paulo Zanoni <paulo.r.zanoni@intel.com>
Signed-off-by: Daniel Vetter <daniel.vetter@ffwll.ch>
diff --git a/drivers/gpu/drm/i915/intel_crt.c b/drivers/gpu/drm/i915/intel_crt.c
index 46c90f5..53f3e875 100644
--- a/drivers/gpu/drm/i915/intel_crt.c
+++ b/drivers/gpu/drm/i915/intel_crt.c
@@ -662,10 +662,22 @@
static void intel_crt_reset(struct drm_connector *connector)
{
struct drm_device *dev = connector->dev;
+ struct drm_i915_private *dev_priv = dev->dev_private;
struct intel_crt *crt = intel_attached_crt(connector);
- if (HAS_PCH_SPLIT(dev))
+ if (HAS_PCH_SPLIT(dev)) {
+ u32 adpa;
+
+ adpa = I915_READ(PCH_ADPA);
+ adpa &= ~ADPA_CRT_HOTPLUG_MASK;
+ adpa |= ADPA_HOTPLUG_BITS;
+ I915_WRITE(PCH_ADPA, adpa);
+ POSTING_READ(PCH_ADPA);
+
+ DRM_DEBUG_KMS("pch crt adpa set to 0x%x\n", adpa);
crt->force_hotplug_required = 1;
+ }
+
}
/*
@@ -784,18 +796,6 @@
* Configure the automatic hotplug detection stuff
*/
crt->force_hotplug_required = 0;
- if (HAS_PCH_SPLIT(dev)) {
- u32 adpa;
-
- adpa = I915_READ(PCH_ADPA);
- adpa &= ~ADPA_CRT_HOTPLUG_MASK;
- adpa |= ADPA_HOTPLUG_BITS;
- I915_WRITE(PCH_ADPA, adpa);
- POSTING_READ(PCH_ADPA);
-
- DRM_DEBUG_KMS("pch crt adpa set to 0x%x\n", adpa);
- crt->force_hotplug_required = 1;
- }
dev_priv->hotplug_supported_mask |= CRT_HOTPLUG_INT_STATUS;
}