[SCSI] bfa: Observed auto D-port mode instead of manual
Observed Auto mode in the HBA side while doing manual D-Port test on the
switch side. Mode is not passed to BFA from firmware when the test is
triggered by switch side. BFA just blindly using Auto mode.
Signed-off-by: Vijaya Mohan Guvva <vmohan@brocade.com>
Signed-off-by: James Bottomley <JBottomley@Parallels.com>
diff --git a/drivers/scsi/bfa/bfa_svc.c b/drivers/scsi/bfa/bfa_svc.c
index 6c41e57..625225f 100644
--- a/drivers/scsi/bfa/bfa_svc.c
+++ b/drivers/scsi/bfa/bfa_svc.c
@@ -6758,7 +6758,7 @@
dport->rp_pwwn = msg->info.teststart.pwwn;
dport->rp_nwwn = msg->info.teststart.nwwn;
dport->lpcnt = cpu_to_be32(msg->info.teststart.numfrm);
- bfa_dport_result_start(dport, BFA_DPORT_OPMODE_AUTO);
+ bfa_dport_result_start(dport, msg->info.teststart.mode);
break;
case BFI_DPORT_SCN_SUBTESTSTART:
diff --git a/drivers/scsi/bfa/bfi.h b/drivers/scsi/bfa/bfi.h
index bf05cc8..9ef91f9 100644
--- a/drivers/scsi/bfa/bfi.h
+++ b/drivers/scsi/bfa/bfi.h
@@ -1144,7 +1144,8 @@
wwn_t pwwn; /* switch port wwn. 8 bytes */
wwn_t nwwn; /* switch node wwn. 8 bytes */
u8 type; /* bfa_diag_dport_test_type_e */
- u8 rsvd[3];
+ u8 mode; /* bfa_diag_dport_test_opmode */
+ u8 rsvd[2];
u32 numfrm; /* from switch uint in 1M */
};