uwb: add the UWB stack (build system)
The Kbuild and Kconfig files.
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
Signed-off-by: David Vrabel <david.vrabel@csr.com>
diff --git a/drivers/uwb/Kconfig b/drivers/uwb/Kconfig
new file mode 100644
index 0000000..3f01a69
--- /dev/null
+++ b/drivers/uwb/Kconfig
@@ -0,0 +1,28 @@
+#
+# UWB device configuration
+#
+
+menuconfig UWB
+ tristate "Ultra Wide Band devices"
+ depends on PCI
+ default n
+ help
+ UWB is a high-bandwidth, low-power, point-to-point radio
+ technology using a wide spectrum (3.1-10.6GHz). It is
+ optimized for in-room use (480Mbps at 2 meters, 110Mbps at
+ 10m). It serves as the transport layer for other protocols,
+ such as Wireless USB (WUSB), IP (WLP) and upcoming
+ Bluetooth and 1394
+
+ The topology is peer to peer; however, higher level
+ protocols (such as WUSB) might impose a master/slave
+ relationship.
+
+ Say Y here if your computer has UWB radio controllers (USB or PCI)
+ based. You will need to enable the radio controllers
+ below. It is ok to select all of them, no harm done.
+
+ For more help check the UWB and WUSB related files in
+ <file:Documentation/usb/>.
+
+ To compile the UWB stack as a module, choose M here.