| /* |
| * Copyright (C) 2014 Hauke Mehrtens <hauke@hauke-m.de> |
| * Copyright (C) 2015 Broadcom Corporatcommon ion |
| * |
| * This program is free software; you can redistribute it and/or |
| * modify it under the terms of the GNU General Public License as |
| * published by the Free Software Foundation version 2. |
| * |
| * This program is distributed "as is" WITHOUT ANY WARRANTY of any |
| * kind, whether express or implied; without even the implied warranty |
| * of MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the |
| * GNU General Public License for more details. |
| */ |
| |
| #include <linux/kernel.h> |
| #include <linux/pci.h> |
| #include <linux/msi.h> |
| #include <linux/clk.h> |
| #include <linux/module.h> |
| #include <linux/mbus.h> |
| #include <linux/slab.h> |
| #include <linux/delay.h> |
| #include <linux/interrupt.h> |
| #include <linux/platform_device.h> |
| #include <linux/of_address.h> |
| #include <linux/of_pci.h> |
| #include <linux/of_irq.h> |
| #include <linux/of_platform.h> |
| #include <linux/phy/phy.h> |
| |
| #include "pcie-iproc.h" |
| |
| #define CLK_CONTROL_OFFSET 0x000 |
| #define EP_MODE_SURVIVE_PERST_SHIFT 1 |
| #define EP_MODE_SURVIVE_PERST BIT(EP_MODE_SURVIVE_PERST_SHIFT) |
| #define RC_PCIE_RST_OUTPUT_SHIFT 0 |
| #define RC_PCIE_RST_OUTPUT BIT(RC_PCIE_RST_OUTPUT_SHIFT) |
| |
| #define CFG_IND_ADDR_OFFSET 0x120 |
| #define CFG_IND_ADDR_MASK 0x00001ffc |
| |
| #define CFG_IND_DATA_OFFSET 0x124 |
| |
| #define CFG_ADDR_OFFSET 0x1f8 |
| #define CFG_ADDR_BUS_NUM_SHIFT 20 |
| #define CFG_ADDR_BUS_NUM_MASK 0x0ff00000 |
| #define CFG_ADDR_DEV_NUM_SHIFT 15 |
| #define CFG_ADDR_DEV_NUM_MASK 0x000f8000 |
| #define CFG_ADDR_FUNC_NUM_SHIFT 12 |
| #define CFG_ADDR_FUNC_NUM_MASK 0x00007000 |
| #define CFG_ADDR_REG_NUM_SHIFT 2 |
| #define CFG_ADDR_REG_NUM_MASK 0x00000ffc |
| #define CFG_ADDR_CFG_TYPE_SHIFT 0 |
| #define CFG_ADDR_CFG_TYPE_MASK 0x00000003 |
| |
| #define CFG_DATA_OFFSET 0x1fc |
| |
| #define SYS_RC_INTX_EN 0x330 |
| #define SYS_RC_INTX_MASK 0xf |
| |
| static inline struct iproc_pcie *iproc_data(struct pci_bus *bus) |
| { |
| struct iproc_pcie *pcie; |
| #ifdef CONFIG_ARM |
| struct pci_sys_data *sys = bus->sysdata; |
| |
| pcie = sys->private_data; |
| #else |
| pcie = bus->sysdata; |
| #endif |
| return pcie; |
| } |
| |
| /** |
| * Note access to the configuration registers are protected at the higher layer |
| * by 'pci_lock' in drivers/pci/access.c |
| */ |
| static void __iomem *iproc_pcie_map_cfg_bus(struct pci_bus *bus, |
| unsigned int devfn, |
| int where) |
| { |
| struct iproc_pcie *pcie = iproc_data(bus); |
| unsigned slot = PCI_SLOT(devfn); |
| unsigned fn = PCI_FUNC(devfn); |
| unsigned busno = bus->number; |
| u32 val; |
| |
| /* root complex access */ |
| if (busno == 0) { |
| if (slot >= 1) |
| return NULL; |
| writel(where & CFG_IND_ADDR_MASK, |
| pcie->base + CFG_IND_ADDR_OFFSET); |
| return (pcie->base + CFG_IND_DATA_OFFSET); |
| } |
| |
| if (fn > 1) |
| return NULL; |
| |
| /* EP device access */ |
| val = (busno << CFG_ADDR_BUS_NUM_SHIFT) | |
| (slot << CFG_ADDR_DEV_NUM_SHIFT) | |
| (fn << CFG_ADDR_FUNC_NUM_SHIFT) | |
| (where & CFG_ADDR_REG_NUM_MASK) | |
| (1 & CFG_ADDR_CFG_TYPE_MASK); |
| writel(val, pcie->base + CFG_ADDR_OFFSET); |
| |
| return (pcie->base + CFG_DATA_OFFSET); |
| } |
| |
| static struct pci_ops iproc_pcie_ops = { |
| .map_bus = iproc_pcie_map_cfg_bus, |
| .read = pci_generic_config_read32, |
| .write = pci_generic_config_write32, |
| }; |
| |
| static void iproc_pcie_reset(struct iproc_pcie *pcie) |
| { |
| u32 val; |
| |
| /* |
| * Configure the PCIe controller as root complex and send a downstream |
| * reset |
| */ |
| val = EP_MODE_SURVIVE_PERST | RC_PCIE_RST_OUTPUT; |
| writel(val, pcie->base + CLK_CONTROL_OFFSET); |
| udelay(250); |
| val &= ~EP_MODE_SURVIVE_PERST; |
| writel(val, pcie->base + CLK_CONTROL_OFFSET); |
| msleep(250); |
| } |
| |
| static int iproc_pcie_check_link(struct iproc_pcie *pcie, struct pci_bus *bus) |
| { |
| u8 hdr_type; |
| u32 link_ctrl; |
| u16 pos, link_status; |
| int link_is_active = 0; |
| |
| /* make sure we are not in EP mode */ |
| pci_bus_read_config_byte(bus, 0, PCI_HEADER_TYPE, &hdr_type); |
| if ((hdr_type & 0x7f) != PCI_HEADER_TYPE_BRIDGE) { |
| dev_err(pcie->dev, "in EP mode, hdr=%#02x\n", hdr_type); |
| return -EFAULT; |
| } |
| |
| /* force class to PCI_CLASS_BRIDGE_PCI (0x0604) */ |
| pci_bus_write_config_word(bus, 0, PCI_CLASS_DEVICE, |
| PCI_CLASS_BRIDGE_PCI); |
| |
| /* check link status to see if link is active */ |
| pos = pci_bus_find_capability(bus, 0, PCI_CAP_ID_EXP); |
| pci_bus_read_config_word(bus, 0, pos + PCI_EXP_LNKSTA, &link_status); |
| if (link_status & PCI_EXP_LNKSTA_NLW) |
| link_is_active = 1; |
| |
| if (!link_is_active) { |
| /* try GEN 1 link speed */ |
| #define PCI_LINK_STATUS_CTRL_2_OFFSET 0x0dc |
| #define PCI_TARGET_LINK_SPEED_MASK 0xf |
| #define PCI_TARGET_LINK_SPEED_GEN2 0x2 |
| #define PCI_TARGET_LINK_SPEED_GEN1 0x1 |
| pci_bus_read_config_dword(bus, 0, |
| PCI_LINK_STATUS_CTRL_2_OFFSET, |
| &link_ctrl); |
| if ((link_ctrl & PCI_TARGET_LINK_SPEED_MASK) == |
| PCI_TARGET_LINK_SPEED_GEN2) { |
| link_ctrl &= ~PCI_TARGET_LINK_SPEED_MASK; |
| link_ctrl |= PCI_TARGET_LINK_SPEED_GEN1; |
| pci_bus_write_config_dword(bus, 0, |
| PCI_LINK_STATUS_CTRL_2_OFFSET, |
| link_ctrl); |
| msleep(100); |
| |
| pos = pci_bus_find_capability(bus, 0, PCI_CAP_ID_EXP); |
| pci_bus_read_config_word(bus, 0, pos + PCI_EXP_LNKSTA, |
| &link_status); |
| if (link_status & PCI_EXP_LNKSTA_NLW) |
| link_is_active = 1; |
| } |
| } |
| |
| dev_info(pcie->dev, "link: %s\n", link_is_active ? "UP" : "DOWN"); |
| |
| return link_is_active ? 0 : -ENODEV; |
| } |
| |
| static void iproc_pcie_enable(struct iproc_pcie *pcie) |
| { |
| writel(SYS_RC_INTX_MASK, pcie->base + SYS_RC_INTX_EN); |
| } |
| |
| int iproc_pcie_setup(struct iproc_pcie *pcie, struct list_head *res) |
| { |
| int ret; |
| void *sysdata; |
| struct pci_bus *bus; |
| |
| if (!pcie || !pcie->dev || !pcie->base) |
| return -EINVAL; |
| |
| ret = phy_init(pcie->phy); |
| if (ret) { |
| dev_err(pcie->dev, "unable to initialize PCIe PHY\n"); |
| return ret; |
| } |
| |
| ret = phy_power_on(pcie->phy); |
| if (ret) { |
| dev_err(pcie->dev, "unable to power on PCIe PHY\n"); |
| goto err_exit_phy; |
| } |
| |
| iproc_pcie_reset(pcie); |
| |
| #ifdef CONFIG_ARM |
| pcie->sysdata.private_data = pcie; |
| sysdata = &pcie->sysdata; |
| #else |
| sysdata = pcie; |
| #endif |
| |
| bus = pci_create_root_bus(pcie->dev, 0, &iproc_pcie_ops, sysdata, res); |
| if (!bus) { |
| dev_err(pcie->dev, "unable to create PCI root bus\n"); |
| ret = -ENOMEM; |
| goto err_power_off_phy; |
| } |
| pcie->root_bus = bus; |
| |
| ret = iproc_pcie_check_link(pcie, bus); |
| if (ret) { |
| dev_err(pcie->dev, "no PCIe EP device detected\n"); |
| goto err_rm_root_bus; |
| } |
| |
| iproc_pcie_enable(pcie); |
| |
| pci_scan_child_bus(bus); |
| pci_assign_unassigned_bus_resources(bus); |
| #ifdef CONFIG_ARM |
| pci_fixup_irqs(pci_common_swizzle, pcie->map_irq); |
| #endif |
| pci_bus_add_devices(bus); |
| |
| return 0; |
| |
| err_rm_root_bus: |
| pci_stop_root_bus(bus); |
| pci_remove_root_bus(bus); |
| |
| err_power_off_phy: |
| phy_power_off(pcie->phy); |
| err_exit_phy: |
| phy_exit(pcie->phy); |
| return ret; |
| } |
| EXPORT_SYMBOL(iproc_pcie_setup); |
| |
| int iproc_pcie_remove(struct iproc_pcie *pcie) |
| { |
| pci_stop_root_bus(pcie->root_bus); |
| pci_remove_root_bus(pcie->root_bus); |
| |
| phy_power_off(pcie->phy); |
| phy_exit(pcie->phy); |
| |
| return 0; |
| } |
| EXPORT_SYMBOL(iproc_pcie_remove); |
| |
| MODULE_AUTHOR("Ray Jui <rjui@broadcom.com>"); |
| MODULE_DESCRIPTION("Broadcom iPROC PCIe common driver"); |
| MODULE_LICENSE("GPL v2"); |