mmc: sdhci: Fix FSL ESDHC reset handling quirk
The commit 0718e59ae259 ("mmc: sdhci: move FSL ESDHC reset handling quirk into
esdhc code") states that Freescale esdhc is the only controller which needs
the interrupt registers restored after a reset. So it moves
SDHCI_QUIRK_RESTORE_IRQS_AFTER_RESET quirk handling code into the
esdhc-imx driver only. Unfortunately the same controller is used in
other boards which use the of-esdhc driver instead (like powerpc P2020).
Restore interrupts after reset in the sdhci-of-esdhc driver also.
Signed-off-by: Alessio Igor Bogani <alessio.bogani@elettra.eu>
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>
diff --git a/drivers/mmc/host/sdhci-of-esdhc.c b/drivers/mmc/host/sdhci-of-esdhc.c
index 8872c85..4a654d4 100644
--- a/drivers/mmc/host/sdhci-of-esdhc.c
+++ b/drivers/mmc/host/sdhci-of-esdhc.c
@@ -276,6 +276,14 @@
ESDHC_CTRL_BUSWIDTH_MASK, ctrl);
}
+static void esdhc_reset(struct sdhci_host *host, u8 mask)
+{
+ sdhci_reset(host, mask);
+
+ sdhci_writel(host, host->ier, SDHCI_INT_ENABLE);
+ sdhci_writel(host, host->ier, SDHCI_SIGNAL_ENABLE);
+}
+
static const struct sdhci_ops sdhci_esdhc_ops = {
.read_l = esdhc_readl,
.read_w = esdhc_readw,
@@ -290,7 +298,7 @@
.platform_init = esdhc_of_platform_init,
.adma_workaround = esdhci_of_adma_workaround,
.set_bus_width = esdhc_pltfm_set_bus_width,
- .reset = sdhci_reset,
+ .reset = esdhc_reset,
.set_uhs_signaling = sdhci_set_uhs_signaling,
};