tulip: remove redundant D0 power state set
pci_enable_device() will set device power state to D0,
so it's no need to do it again in tulip_init_one().
Signed-off-by: Yijing Wang <wangyijing@huawei.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/dec/tulip/tulip_core.c b/drivers/net/ethernet/dec/tulip/tulip_core.c
index 1e9443d..c94152f 100644
--- a/drivers/net/ethernet/dec/tulip/tulip_core.c
+++ b/drivers/net/ethernet/dec/tulip/tulip_core.c
@@ -1410,12 +1410,6 @@
return i;
}
- /* The chip will fail to enter a low-power state later unless
- * first explicitly commanded into D0 */
- if (pci_set_power_state(pdev, PCI_D0)) {
- pr_notice("Failed to set power state to D0\n");
- }
-
irq = pdev->irq;
/* alloc_etherdev ensures aligned and zeroed private structures */