drm/i915: add port power domains
Parts that poke port specific HW blocks like the encoder HW state
readout or connector hotplug detect code need a way to check whether
required power domains are on or enable/disable these. For this purpose
add a set of power domains that refer to the port HW blocks. Get the
proper port power domains during modeset.
For now when requesting the power domain for a DDI port get it for a 4
lane configuration. This can be optimized later to request only the 2
lane power domain, when proper support is added on the VLV PHY side for
this. Atm, the PHY setup code assumes a 4 lane config in all cases.
Signed-off-by: Imre Deak <imre.deak@intel.com>
Reviewed-by: Jesse Barnes <jbarnes@virtuousgeek.org>
Signed-off-by: Daniel Vetter <daniel.vetter@ffwll.ch>
diff --git a/drivers/gpu/drm/i915/i915_debugfs.c b/drivers/gpu/drm/i915/i915_debugfs.c
index fbcf536..a90d31c 100644
--- a/drivers/gpu/drm/i915/i915_debugfs.c
+++ b/drivers/gpu/drm/i915/i915_debugfs.c
@@ -2048,6 +2048,28 @@
return "TRANSCODER_C";
case POWER_DOMAIN_TRANSCODER_EDP:
return "TRANSCODER_EDP";
+ case POWER_DOMAIN_PORT_DDI_A_2_LANES:
+ return "PORT_DDI_A_2_LANES";
+ case POWER_DOMAIN_PORT_DDI_A_4_LANES:
+ return "PORT_DDI_A_4_LANES";
+ case POWER_DOMAIN_PORT_DDI_B_2_LANES:
+ return "PORT_DDI_B_2_LANES";
+ case POWER_DOMAIN_PORT_DDI_B_4_LANES:
+ return "PORT_DDI_B_4_LANES";
+ case POWER_DOMAIN_PORT_DDI_C_2_LANES:
+ return "PORT_DDI_C_2_LANES";
+ case POWER_DOMAIN_PORT_DDI_C_4_LANES:
+ return "PORT_DDI_C_4_LANES";
+ case POWER_DOMAIN_PORT_DDI_D_2_LANES:
+ return "PORT_DDI_D_2_LANES";
+ case POWER_DOMAIN_PORT_DDI_D_4_LANES:
+ return "PORT_DDI_D_4_LANES";
+ case POWER_DOMAIN_PORT_DSI:
+ return "PORT_DSI";
+ case POWER_DOMAIN_PORT_CRT:
+ return "PORT_CRT";
+ case POWER_DOMAIN_PORT_OTHER:
+ return "PORT_OTHER";
case POWER_DOMAIN_VGA:
return "VGA";
case POWER_DOMAIN_AUDIO: