drivers/leds/leds-lp5521.c: redefinition of register bits
For better readability, values of LP5521_REG_ENABLE register were
redefined= . Additional definitions: LP5521_ENABLE_DEFAULT and
LP5521_ENABLE_RUN_PROGRAM= .
Use definition rather than hard code value.
: 0x3F -> 'LP5521_CMD_DIRECT'
Signed-off-by: Milo(Woogyom) Kim <milo.kim@ti.com>
Acked-by: Linus Walleij <linus.walleij@linaro.org>
Cc: Arun MURTHY <arun.murthy@stericsson.com>
Cc: Srinidhi Kasagar <srinidhi.kasagar@stericsson.com>
Cc: Richard Purdie <rpurdie@rpsys.net>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
diff --git a/drivers/leds/leds-lp5521.c b/drivers/leds/leds-lp5521.c
index 007c7c9..de7b8fe 100644
--- a/drivers/leds/leds-lp5521.c
+++ b/drivers/leds/leds-lp5521.c
@@ -81,6 +81,10 @@
#define LP5521_MASTER_ENABLE 0x40 /* Chip master enable */
#define LP5521_LOGARITHMIC_PWM 0x80 /* Logarithmic PWM adjustment */
#define LP5521_EXEC_RUN 0x2A
+#define LP5521_ENABLE_DEFAULT \
+ (LP5521_MASTER_ENABLE | LP5521_LOGARITHMIC_PWM)
+#define LP5521_ENABLE_RUN_PROGRAM \
+ (LP5521_ENABLE_DEFAULT | LP5521_EXEC_RUN)
/* Status */
#define LP5521_EXT_CLK_USED 0x08
@@ -237,7 +241,7 @@
lp5521_init_engine(chip);
/* Set all PWMs to direct control mode */
- ret = lp5521_write(client, LP5521_REG_OP_MODE, 0x3F);
+ ret = lp5521_write(client, LP5521_REG_OP_MODE, LP5521_CMD_DIRECT);
cfg = chip->pdata->update_config ?
: (LP5521_PWRSAVE_EN | LP5521_CP_MODE_AUTO | LP5521_R_TO_BATT);
@@ -250,8 +254,7 @@
/* Set engines are set to run state when OP_MODE enables engines */
ret |= lp5521_write(client, LP5521_REG_ENABLE,
- LP5521_MASTER_ENABLE | LP5521_LOGARITHMIC_PWM |
- LP5521_EXEC_RUN);
+ LP5521_ENABLE_RUN_PROGRAM);
/* enable takes 500us. 1 - 2 ms leaves some margin */
usleep_range(1000, 2000);
@@ -302,8 +305,7 @@
int ret;
u8 buf;
- ret = lp5521_write(client, LP5521_REG_ENABLE,
- LP5521_MASTER_ENABLE | LP5521_LOGARITHMIC_PWM);
+ ret = lp5521_write(client, LP5521_REG_ENABLE, LP5521_ENABLE_DEFAULT);
if (ret)
return ret;
/* enable takes 500us. 1 - 2 ms leaves some margin */
@@ -311,7 +313,7 @@
ret = lp5521_read(client, LP5521_REG_ENABLE, &buf);
if (ret)
return ret;
- if (buf != (LP5521_MASTER_ENABLE | LP5521_LOGARITHMIC_PWM))
+ if (buf != LP5521_ENABLE_DEFAULT)
return -ENODEV;
return 0;
@@ -576,8 +578,7 @@
return;
if (mode == PATTERN_OFF) {
- lp5521_write(cl, LP5521_REG_ENABLE,
- LP5521_MASTER_ENABLE | LP5521_LOGARITHMIC_PWM);
+ lp5521_write(cl, LP5521_REG_ENABLE, LP5521_ENABLE_DEFAULT);
usleep_range(1000, 2000);
lp5521_write(cl, LP5521_REG_OP_MODE, LP5521_CMD_DIRECT);
} else {
@@ -599,9 +600,7 @@
lp5521_write(cl, LP5521_REG_OP_MODE, LP5521_CMD_RUN);
usleep_range(1000, 2000);
- lp5521_write(cl, LP5521_REG_ENABLE,
- LP5521_MASTER_ENABLE | LP5521_LOGARITHMIC_PWM |
- LP5521_EXEC_RUN);
+ lp5521_write(cl, LP5521_REG_ENABLE, LP5521_ENABLE_RUN_PROGRAM);
}
}