usb: dwc3: workaround: clock gating issues
Revisions between 2.10a and 2.50a (included) have
a known issue which may cause xHCI compliance tests
to fail and/or quality issues with Isochronous
transactions.
Note that this issue only impacts certain configurations
of those revisions, namely the ones which have clock
gating enabled.
The suggested workaround is to disable clock gating in
known broken revisions, make sure HW LPM is disabled
and set GCTL.SOFITPSYNC to 1.
Signed-off-by: Felipe Balbi <balbi@ti.com>
diff --git a/drivers/usb/dwc3/core.c b/drivers/usb/dwc3/core.c
index a49217a..785feee 100644
--- a/drivers/usb/dwc3/core.c
+++ b/drivers/usb/dwc3/core.c
@@ -314,7 +314,25 @@
switch (DWC3_GHWPARAMS1_EN_PWROPT(dwc->hwparams.hwparams1)) {
case DWC3_GHWPARAMS1_EN_PWROPT_CLK:
- reg &= ~DWC3_GCTL_DSBLCLKGTNG;
+ /**
+ * WORKAROUND: DWC3 revisions between 2.10a and 2.50a have an
+ * issue which would cause xHCI compliance tests to fail.
+ *
+ * Because of that we cannot enable clock gating on such
+ * configurations.
+ *
+ * Refers to:
+ *
+ * STAR#9000588375: Clock Gating, SOF Issues when ref_clk-Based
+ * SOF/ITP Mode Used
+ */
+ if ((dwc->dr_mode == USB_DR_MODE_HOST ||
+ dwc->dr_mode == USB_DR_MODE_OTG) &&
+ (dwc->revision >= DWC3_REVISION_210A &&
+ dwc->revision <= DWC3_REVISION_250A))
+ reg |= DWC3_GCTL_DSBLCLKGTNG | DWC3_GCTL_SOFITPSYNC;
+ else
+ reg &= ~DWC3_GCTL_DSBLCLKGTNG;
break;
default:
dev_dbg(dwc->dev, "No power optimization available\n");
@@ -479,6 +497,14 @@
goto err0;
}
+ if (IS_ENABLED(CONFIG_USB_DWC3_HOST))
+ dwc->dr_mode = USB_DR_MODE_HOST;
+ else if (IS_ENABLED(CONFIG_USB_DWC3_GADGET))
+ dwc->dr_mode = USB_DR_MODE_PERIPHERAL;
+
+ if (dwc->dr_mode == USB_DR_MODE_UNKNOWN)
+ dwc->dr_mode = USB_DR_MODE_OTG;
+
ret = dwc3_core_init(dwc);
if (ret) {
dev_err(dev, "failed to initialize core\n");
@@ -494,14 +520,6 @@
goto err1;
}
- if (IS_ENABLED(CONFIG_USB_DWC3_HOST))
- dwc->dr_mode = USB_DR_MODE_HOST;
- else if (IS_ENABLED(CONFIG_USB_DWC3_GADGET))
- dwc->dr_mode = USB_DR_MODE_PERIPHERAL;
-
- if (dwc->dr_mode == USB_DR_MODE_UNKNOWN)
- dwc->dr_mode = USB_DR_MODE_OTG;
-
switch (dwc->dr_mode) {
case USB_DR_MODE_PERIPHERAL:
dwc3_set_mode(dwc, DWC3_GCTL_PRTCAP_DEVICE);