bnx2x: Spelling mistakes
Spelling mistakes
Spelling has to L's in it...
Signed-off-by: Eilon Greenstein <eilong@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/bnx2x_init.h b/drivers/net/bnx2x_init.h
index 4c77507..f62891b 100644
--- a/drivers/net/bnx2x_init.h
+++ b/drivers/net/bnx2x_init.h
@@ -208,7 +208,7 @@
/*********************************************************
There are different blobs for each PRAM section.
In addition, each blob write operation is divided into a few operations
- in order to decrease the amount of phys. contigious buffer needed.
+ in order to decrease the amount of phys. contiguous buffer needed.
Thus, when we select a blob the address may be with some offset
from the beginning of PRAM section.
The same holds for the INT_TABLE sections.
@@ -336,7 +336,7 @@
len = op->str_wr.data_len;
data = data_base + op->str_wr.data_off;
- /* carefull! it must be in order */
+ /* careful! it must be in order */
if (unlikely(op_type > OP_WB)) {
/* If E1 only */
@@ -740,7 +740,7 @@
return crc_res;
}
-/* regiesers addresses are not in order
+/* registers addresses are not in order
so these arrays help simplify the code */
static const int cm_start[E1H_FUNC_MAX][9] = {
{MISC_FUNC0_START, TCM_FUNC0_START, UCM_FUNC0_START, CCM_FUNC0_START,