ASoC: wm_adsp: Move DSP Rate controls into the codec
The rate controls are codec-specific, it's not possible to
generically say what the range or the meaning of each control
is (or even if they exist at all) - that depends on the
particular codec.
This is currently being handled for Arizona codecs by putting
an Arizona-specific table of controls inside the wm_adsp driver.
This creates a dependency between wm_adsp and arizona.c, and is an
awkward solution if the ADSP is used in another family of codecs
Fix this by moving the Arizona-specific rate controls into the
Arizona codec drivers.
Signed-off-by: Richard Fitzgerald <rf@opensource.wolfsonmicro.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
diff --git a/sound/soc/codecs/wm5110.c b/sound/soc/codecs/wm5110.c
index 2265967..944354d 100644
--- a/sound/soc/codecs/wm5110.c
+++ b/sound/soc/codecs/wm5110.c
@@ -1614,6 +1614,12 @@
return ret;
}
+ ret = snd_soc_add_codec_controls(codec,
+ arizona_adsp2_rate_controls,
+ WM5110_NUM_ADSP);
+ if (ret)
+ return ret;
+
snd_soc_dapm_disable_pin(dapm, "HAPTICS");
return 0;