ssb: Convert ssb_printk to ssb_<level>
Use a more current logging style.
Convert ssb_dbprint to ssb_dbg too.
Signed-off-by: Joe Perches <joe@perches.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/ssb/driver_pcicore.c b/drivers/ssb/driver_pcicore.c
index 59801d2..d75b72b 100644
--- a/drivers/ssb/driver_pcicore.c
+++ b/drivers/ssb/driver_pcicore.c
@@ -263,8 +263,7 @@
return -ENODEV;
}
- ssb_printk(KERN_INFO "PCI: Fixing up device %s\n",
- pci_name(d));
+ ssb_info("PCI: Fixing up device %s\n", pci_name(d));
/* Fix up interrupt lines */
d->irq = ssb_mips_irq(extpci_core->dev) + 2;
@@ -285,12 +284,12 @@
if (dev->bus->number != 0 || PCI_SLOT(dev->devfn) != 0)
return;
- ssb_printk(KERN_INFO "PCI: Fixing up bridge %s\n", pci_name(dev));
+ ssb_info("PCI: Fixing up bridge %s\n", pci_name(dev));
/* Enable PCI bridge bus mastering and memory space */
pci_set_master(dev);
if (pcibios_enable_device(dev, ~0) < 0) {
- ssb_printk(KERN_ERR "PCI: SSB bridge enable failed\n");
+ ssb_err("PCI: SSB bridge enable failed\n");
return;
}
@@ -299,8 +298,8 @@
/* Make sure our latency is high enough to handle the devices behind us */
lat = 168;
- ssb_printk(KERN_INFO "PCI: Fixing latency timer of device %s to %u\n",
- pci_name(dev), lat);
+ ssb_info("PCI: Fixing latency timer of device %s to %u\n",
+ pci_name(dev), lat);
pci_write_config_byte(dev, PCI_LATENCY_TIMER, lat);
}
DECLARE_PCI_FIXUP_EARLY(PCI_ANY_ID, PCI_ANY_ID, ssb_pcicore_fixup_pcibridge);
@@ -323,7 +322,7 @@
return;
extpci_core = pc;
- ssb_dprintk(KERN_INFO PFX "PCIcore in host mode found\n");
+ ssb_dbg("PCIcore in host mode found\n");
/* Reset devices on the external PCI bus */
val = SSB_PCICORE_CTL_RST_OE;
val |= SSB_PCICORE_CTL_CLK_OE;
@@ -338,7 +337,7 @@
udelay(1); /* Assertion time demanded by the PCI standard */
if (pc->dev->bus->has_cardbus_slot) {
- ssb_dprintk(KERN_INFO PFX "CardBus slot detected\n");
+ ssb_dbg("CardBus slot detected\n");
pc->cardbusmode = 1;
/* GPIO 1 resets the bridge */
ssb_gpio_out(pc->dev->bus, 1, 1);