ARM: dts: msm: Optimize NT36850 panel initialized code
The CLK_POST time should be set larger. Need some delay
when the power off. Enable ESD check for this panel.
Change-Id: I2ea9bc24e98fe1ff748cb145c0d9a743cba995f0
Signed-off-by: Yuan Zhao <yzhao@codeaurora.org>
diff --git a/arch/arm64/boot/dts/qcom/sdm670-sde-display.dtsi b/arch/arm64/boot/dts/qcom/sdm670-sde-display.dtsi
index 4e3683c..374e7ec 100644
--- a/arch/arm64/boot/dts/qcom/sdm670-sde-display.dtsi
+++ b/arch/arm64/boot/dts/qcom/sdm670-sde-display.dtsi
@@ -825,8 +825,15 @@
};
&dsi_dual_nt36850_truly_cmd {
- qcom,mdss-dsi-t-clk-post = <0x0E>;
+ qcom,mdss-dsi-t-clk-post = <0x28>;
qcom,mdss-dsi-t-clk-pre = <0x30>;
+ qcom,esd-check-enabled;
+ qcom,mdss-dsi-panel-status-check-mode = "reg_read";
+ qcom,mdss-dsi-panel-status-command = [06 01 00 01 00 00 01 0a];
+ qcom,mdss-dsi-panel-status-command-state = "dsi_hs_mode";
+ qcom,mdss-dsi-panel-status-value = <0x9c>;
+ qcom,mdss-dsi-panel-on-check-value = <0x9c>;
+ qcom,mdss-dsi-panel-status-read-length = <1>;
qcom,mdss-dsi-display-timings {
timing@0{
qcom,mdss-dsi-panel-phy-timings = [00 1f 08 08 24 23 08