OMAP4: PM: Do not assume clkdm supports hw transitions
omap_set_pwrdm_state today assumes a clkdm supports hw_auto
transitions and hence leaves some which do not support this
in sw wkup state preventing low power transitions.
Signed-off-by: Rajendra Nayak <rnayak@ti.com>
Signed-off-by: Santosh Shilimkar <santosh.shilimkar@ti.com>
Acked-by: Benoit Cousson <b-cousson@ti.com>
Acked-by: Kevin Hilman <khilman@deeprootsystems.com>
Signed-off-by: Paul Walmsley <paul@pwsan.com>
diff --git a/arch/arm/mach-omap2/pm.c b/arch/arm/mach-omap2/pm.c
index a2b826c..9b1db59 100644
--- a/arch/arm/mach-omap2/pm.c
+++ b/arch/arm/mach-omap2/pm.c
@@ -95,8 +95,7 @@
/*
* This sets pwrdm state (other than mpu & core. Currently only ON &
- * RET are supported. Function is assuming that clkdm doesn't have
- * hw_sup mode enabled.
+ * RET are supported.
*/
int omap_set_pwrdm_state(struct powerdomain *pwrdm, u32 state)
{
@@ -137,7 +136,10 @@
switch (sleep_switch) {
case FORCEWAKEUP_SWITCH:
- omap2_clkdm_allow_idle(pwrdm->pwrdm_clkdms[0]);
+ if (pwrdm->pwrdm_clkdms[0]->flags & CLKDM_CAN_ENABLE_AUTO)
+ omap2_clkdm_allow_idle(pwrdm->pwrdm_clkdms[0]);
+ else
+ omap2_clkdm_sleep(pwrdm->pwrdm_clkdms[0]);
break;
case LOWPOWERSTATE_SWITCH:
pwrdm_set_lowpwrstchange(pwrdm);