libata: consistently use msecs for time durations
libata has been using mix of jiffies and msecs for time druations.
This is getting confusing. As writing sub HZ values in jiffies is
PITA and msecs_to_jiffies() can't be used as initializer, unify unit
for all time durations to msecs. So, durations are in msecs and
deadlines are in jiffies. ata_deadline() is added to compute deadline
from a start time and duration in msecs.
While at it, drop now superflous _msec suffix from arguments and
rename @timeout to @deadline if it represents a fixed point in time
rather than duration.
Signed-off-by: Tejun Heo <htejun@gmail.com>
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>
diff --git a/drivers/ata/libata-sff.c b/drivers/ata/libata-sff.c
index c0908c2..304fdc6 100644
--- a/drivers/ata/libata-sff.c
+++ b/drivers/ata/libata-sff.c
@@ -345,8 +345,8 @@
/**
* ata_sff_busy_sleep - sleep until BSY clears, or timeout
* @ap: port containing status register to be polled
- * @tmout_pat: impatience timeout
- * @tmout: overall timeout
+ * @tmout_pat: impatience timeout in msecs
+ * @tmout: overall timeout in msecs
*
* Sleep until ATA Status register bit BSY clears,
* or a timeout occurs.
@@ -365,7 +365,7 @@
status = ata_sff_busy_wait(ap, ATA_BUSY, 300);
timer_start = jiffies;
- timeout = timer_start + tmout_pat;
+ timeout = ata_deadline(timer_start, tmout_pat);
while (status != 0xff && (status & ATA_BUSY) &&
time_before(jiffies, timeout)) {
msleep(50);
@@ -377,7 +377,7 @@
"port is slow to respond, please be patient "
"(Status 0x%x)\n", status);
- timeout = timer_start + tmout;
+ timeout = ata_deadline(timer_start, tmout);
while (status != 0xff && (status & ATA_BUSY) &&
time_before(jiffies, timeout)) {
msleep(50);
@@ -390,7 +390,7 @@
if (status & ATA_BUSY) {
ata_port_printk(ap, KERN_ERR, "port failed to respond "
"(%lu secs, Status 0x%x)\n",
- tmout / HZ, status);
+ DIV_ROUND_UP(tmout, 1000), status);
return -EBUSY;
}
@@ -1888,7 +1888,7 @@
unsigned int dev1 = devmask & (1 << 1);
int rc, ret = 0;
- msleep(ATA_WAIT_AFTER_RESET_MSECS);
+ msleep(ATA_WAIT_AFTER_RESET);
/* always check readiness of the master device */
rc = ata_sff_wait_ready(link, deadline);
@@ -2371,7 +2371,8 @@
/* issue bus reset */
if (ap->flags & ATA_FLAG_SRST) {
- rc = ata_bus_softreset(ap, devmask, jiffies + 40 * HZ);
+ rc = ata_bus_softreset(ap, devmask,
+ ata_deadline(jiffies, 40000));
if (rc && rc != -ENODEV)
goto err_out;
}