| # |
| # PHY Layer Configuration |
| # |
| |
| menuconfig PHYLIB |
| tristate "PHY Device support and infrastructure" |
| depends on NETDEVICES |
| help |
| Ethernet controllers are usually attached to PHY |
| devices. This option provides infrastructure for |
| managing PHY devices. |
| |
| if PHYLIB |
| |
| comment "MII PHY device drivers" |
| |
| config AT803X_PHY |
| tristate "Drivers for Atheros AT803X PHYs" |
| ---help--- |
| Currently supports the AT8030 and AT8035 model |
| |
| config AMD_PHY |
| tristate "Drivers for the AMD PHYs" |
| ---help--- |
| Currently supports the am79c874 |
| |
| config MARVELL_PHY |
| tristate "Drivers for Marvell PHYs" |
| ---help--- |
| Currently has a driver for the 88E1011S |
| |
| config DAVICOM_PHY |
| tristate "Drivers for Davicom PHYs" |
| ---help--- |
| Currently supports dm9161e and dm9131 |
| |
| config QSEMI_PHY |
| tristate "Drivers for Quality Semiconductor PHYs" |
| ---help--- |
| Currently supports the qs6612 |
| |
| config LXT_PHY |
| tristate "Drivers for the Intel LXT PHYs" |
| ---help--- |
| Currently supports the lxt970, lxt971 |
| |
| config CICADA_PHY |
| tristate "Drivers for the Cicada PHYs" |
| ---help--- |
| Currently supports the cis8204 |
| |
| config VITESSE_PHY |
| tristate "Drivers for the Vitesse PHYs" |
| ---help--- |
| Currently supports the vsc8244 |
| |
| config SMSC_PHY |
| tristate "Drivers for SMSC PHYs" |
| ---help--- |
| Currently supports the LAN83C185, LAN8187 and LAN8700 PHYs |
| |
| config BROADCOM_PHY |
| tristate "Drivers for Broadcom PHYs" |
| ---help--- |
| Currently supports the BCM5411, BCM5421, BCM5461, BCM54616S, BCM5464, |
| BCM5481 and BCM5482 PHYs. |
| |
| config BCM63XX_PHY |
| tristate "Drivers for Broadcom 63xx SOCs internal PHY" |
| depends on BCM63XX |
| ---help--- |
| Currently supports the 6348 and 6358 PHYs. |
| |
| config BCM7XXX_PHY |
| tristate "Drivers for Broadcom 7xxx SOCs internal PHYs" |
| ---help--- |
| Currently supports the BCM7366, BCM7439, BCM7445, and |
| 40nm and 65nm generation of BCM7xxx Set Top Box SoCs. |
| |
| config BCM87XX_PHY |
| tristate "Driver for Broadcom BCM8706 and BCM8727 PHYs" |
| help |
| Currently supports the BCM8706 and BCM8727 10G Ethernet PHYs. |
| |
| config ICPLUS_PHY |
| tristate "Drivers for ICPlus PHYs" |
| ---help--- |
| Currently supports the IP175C and IP1001 PHYs. |
| |
| config REALTEK_PHY |
| tristate "Drivers for Realtek PHYs" |
| ---help--- |
| Supports the Realtek 821x PHY. |
| |
| config NATIONAL_PHY |
| tristate "Drivers for National Semiconductor PHYs" |
| ---help--- |
| Currently supports the DP83865 PHY. |
| |
| config STE10XP |
| tristate "Driver for STMicroelectronics STe10Xp PHYs" |
| ---help--- |
| This is the driver for the STe100p and STe101p PHYs. |
| |
| config LSI_ET1011C_PHY |
| tristate "Driver for LSI ET1011C PHY" |
| ---help--- |
| Supports the LSI ET1011C PHY. |
| |
| config MICREL_PHY |
| tristate "Driver for Micrel PHYs" |
| ---help--- |
| Supports the KSZ9021, VSC8201, KS8001 PHYs. |
| |
| config DP83867_PHY |
| tristate "Drivers for Texas Instruments DP83867 Gigabit PHY" |
| ---help--- |
| Currently supports the DP83867 PHY. |
| |
| config FIXED_PHY |
| tristate "Driver for MDIO Bus/PHY emulation with fixed speed/link PHYs" |
| depends on PHYLIB |
| ---help--- |
| Adds the platform "fixed" MDIO Bus to cover the boards that use |
| PHYs that are not connected to the real MDIO bus. |
| |
| Currently tested with mpc866ads and mpc8349e-mitx. |
| |
| config MDIO_BITBANG |
| tristate "Support for bitbanged MDIO buses" |
| help |
| This module implements the MDIO bus protocol in software, |
| for use by low level drivers that export the ability to |
| drive the relevant pins. |
| |
| If in doubt, say N. |
| |
| config MDIO_GPIO |
| tristate "Support for GPIO lib-based bitbanged MDIO buses" |
| depends on MDIO_BITBANG && GPIOLIB |
| ---help--- |
| Supports GPIO lib-based MDIO busses. |
| |
| To compile this driver as a module, choose M here: the module |
| will be called mdio-gpio. |
| |
| config MDIO_OCTEON |
| tristate "Support for MDIO buses on Octeon SOCs" |
| depends on CAVIUM_OCTEON_SOC |
| default y |
| help |
| |
| This module provides a driver for the Octeon MDIO busses. |
| It is required by the Octeon Ethernet device drivers. |
| |
| If in doubt, say Y. |
| |
| config MDIO_SUN4I |
| tristate "Allwinner sun4i MDIO interface support" |
| depends on ARCH_SUNXI |
| help |
| This driver supports the MDIO interface found in the network |
| interface units of the Allwinner SoC that have an EMAC (A10, |
| A12, A10s, etc.) |
| |
| config MDIO_MOXART |
| tristate "MOXA ART MDIO interface support" |
| depends on ARCH_MOXART |
| help |
| This driver supports the MDIO interface found in the network |
| interface units of the MOXA ART SoC |
| |
| config MDIO_BUS_MUX |
| tristate |
| depends on OF_MDIO |
| help |
| This module provides a driver framework for MDIO bus |
| multiplexers which connect one of several child MDIO busses |
| to a parent bus. Switching between child busses is done by |
| device specific drivers. |
| |
| config MDIO_BUS_MUX_GPIO |
| tristate "Support for GPIO controlled MDIO bus multiplexers" |
| depends on OF_GPIO && OF_MDIO |
| select MDIO_BUS_MUX |
| help |
| This module provides a driver for MDIO bus multiplexers that |
| are controlled via GPIO lines. The multiplexer connects one of |
| several child MDIO busses to a parent bus. Child bus |
| selection is under the control of GPIO lines. |
| |
| config MDIO_BUS_MUX_MMIOREG |
| tristate "Support for MMIO device-controlled MDIO bus multiplexers" |
| depends on OF_MDIO && HAS_IOMEM |
| select MDIO_BUS_MUX |
| help |
| This module provides a driver for MDIO bus multiplexers that |
| are controlled via a simple memory-mapped device, like an FPGA. |
| The multiplexer connects one of several child MDIO busses to a |
| parent bus. Child bus selection is under the control of one of |
| the FPGA's registers. |
| |
| Currently, only 8-bit registers are supported. |
| |
| config MDIO_BCM_UNIMAC |
| tristate "Broadcom UniMAC MDIO bus controller" |
| depends on HAS_IOMEM |
| help |
| This module provides a driver for the Broadcom UniMAC MDIO busses. |
| This hardware can be found in the Broadcom GENET Ethernet MAC |
| controllers as well as some Broadcom Ethernet switches such as the |
| Starfighter 2 switches. |
| endif # PHYLIB |
| |
| config MICREL_KS8995MA |
| tristate "Micrel KS8995MA 5-ports 10/100 managed Ethernet switch" |
| depends on SPI |