ath10k: enable beacon loss detection support for 10.4
Enable beacon loss detection support for 10.4 by handling
roam event. With this change QCA99X0 station is able to
detect beacon loss when the AP is powered off
Signed-off-by: Mohammed Shafi Shajakhan <mohammed@qti.qualcomm.com>
Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>
diff --git a/drivers/net/wireless/ath/ath10k/wmi.c b/drivers/net/wireless/ath/ath10k/wmi.c
index 4ecf3b3..12a4347 100644
--- a/drivers/net/wireless/ath/ath10k/wmi.c
+++ b/drivers/net/wireless/ath/ath10k/wmi.c
@@ -5259,6 +5259,9 @@
case WMI_10_4_PEER_STA_KICKOUT_EVENTID:
ath10k_wmi_event_peer_sta_kickout(ar, skb);
break;
+ case WMI_10_4_ROAM_EVENTID:
+ ath10k_wmi_event_roam(ar, skb);
+ break;
case WMI_10_4_HOST_SWBA_EVENTID:
ath10k_wmi_event_host_swba(ar, skb);
break;
@@ -7905,6 +7908,7 @@
.pull_phyerr = ath10k_wmi_10_4_op_pull_phyerr_ev,
.pull_svc_rdy = ath10k_wmi_main_op_pull_svc_rdy_ev,
.pull_rdy = ath10k_wmi_op_pull_rdy_ev,
+ .pull_roam_ev = ath10k_wmi_op_pull_roam_ev,
.get_txbf_conf_scheme = ath10k_wmi_10_4_txbf_conf_scheme,
.gen_pdev_suspend = ath10k_wmi_op_gen_pdev_suspend,