MIPS: Replace MIPS-specific 64BIT_PHYS_ADDR with generic PHYS_ADDR_T_64BIT

Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
diff --git a/arch/mips/mm/tlbex.c b/arch/mips/mm/tlbex.c
index b5f228e..7994368 100644
--- a/arch/mips/mm/tlbex.c
+++ b/arch/mips/mm/tlbex.c
@@ -637,7 +637,7 @@
 	if (cpu_has_rixi) {
 		UASM_i_ROTR(p, reg, reg, ilog2(_PAGE_GLOBAL));
 	} else {
-#ifdef CONFIG_64BIT_PHYS_ADDR
+#ifdef CONFIG_PHYS_ADDR_T_64BIT
 		uasm_i_dsrl_safe(p, reg, reg, ilog2(_PAGE_GLOBAL));
 #else
 		UASM_i_SRL(p, reg, reg, ilog2(_PAGE_GLOBAL));
@@ -1009,7 +1009,7 @@
 	 * 64bit address support (36bit on a 32bit CPU) in a 32bit
 	 * Kernel is a special case. Only a few CPUs use it.
 	 */
-#ifdef CONFIG_64BIT_PHYS_ADDR
+#ifdef CONFIG_PHYS_ADDR_T_64BIT
 	if (cpu_has_64bits) {
 		uasm_i_ld(p, tmp, 0, ptep); /* get even pte */
 		uasm_i_ld(p, ptep, sizeof(pte_t), ptep); /* get odd pte */
@@ -1510,14 +1510,14 @@
 iPTE_LW(u32 **p, unsigned int pte, unsigned int ptr)
 {
 #ifdef CONFIG_SMP
-# ifdef CONFIG_64BIT_PHYS_ADDR
+# ifdef CONFIG_PHYS_ADDR_T_64BIT
 	if (cpu_has_64bits)
 		uasm_i_lld(p, pte, 0, ptr);
 	else
 # endif
 		UASM_i_LL(p, pte, 0, ptr);
 #else
-# ifdef CONFIG_64BIT_PHYS_ADDR
+# ifdef CONFIG_PHYS_ADDR_T_64BIT
 	if (cpu_has_64bits)
 		uasm_i_ld(p, pte, 0, ptr);
 	else
@@ -1530,13 +1530,13 @@
 iPTE_SW(u32 **p, struct uasm_reloc **r, unsigned int pte, unsigned int ptr,
 	unsigned int mode)
 {
-#ifdef CONFIG_64BIT_PHYS_ADDR
+#ifdef CONFIG_PHYS_ADDR_T_64BIT
 	unsigned int hwmode = mode & (_PAGE_VALID | _PAGE_DIRTY);
 #endif
 
 	uasm_i_ori(p, pte, pte, mode);
 #ifdef CONFIG_SMP
-# ifdef CONFIG_64BIT_PHYS_ADDR
+# ifdef CONFIG_PHYS_ADDR_T_64BIT
 	if (cpu_has_64bits)
 		uasm_i_scd(p, pte, 0, ptr);
 	else
@@ -1548,7 +1548,7 @@
 	else
 		uasm_il_beqz(p, r, pte, label_smp_pgtable_change);
 
-# ifdef CONFIG_64BIT_PHYS_ADDR
+# ifdef CONFIG_PHYS_ADDR_T_64BIT
 	if (!cpu_has_64bits) {
 		/* no uasm_i_nop needed */
 		uasm_i_ll(p, pte, sizeof(pte_t) / 2, ptr);
@@ -1563,14 +1563,14 @@
 	uasm_i_nop(p);
 # endif
 #else
-# ifdef CONFIG_64BIT_PHYS_ADDR
+# ifdef CONFIG_PHYS_ADDR_T_64BIT
 	if (cpu_has_64bits)
 		uasm_i_sd(p, pte, 0, ptr);
 	else
 # endif
 		UASM_i_SW(p, pte, 0, ptr);
 
-# ifdef CONFIG_64BIT_PHYS_ADDR
+# ifdef CONFIG_PHYS_ADDR_T_64BIT
 	if (!cpu_has_64bits) {
 		uasm_i_lw(p, pte, sizeof(pte_t) / 2, ptr);
 		uasm_i_ori(p, pte, pte, hwmode);