spi: Eliminate 3WIRE spi_transfer check
Checking for SPI_3WIRE isn't needed. spi_setup() already prevents 3WIRE
mode from being combined with DUAL or QUAD mode support. So there is no
need to differentiate between a single bit device with SPI_3WIRE set and
one with without. It doesn't change the allowed bit widths.
Signed-off-by: Trent Piepho <tpiepho@gmail.com>
Signed-off-by: Mark Brown <broonie@linaro.org>
diff --git a/drivers/spi/spi.c b/drivers/spi/spi.c
index 857ee8c..2cd9fdc 100644
--- a/drivers/spi/spi.c
+++ b/drivers/spi/spi.c
@@ -1678,9 +1678,6 @@
if ((xfer->tx_nbits == SPI_NBITS_QUAD) &&
!(spi->mode & SPI_TX_QUAD))
return -EINVAL;
- if ((spi->mode & SPI_3WIRE) &&
- (xfer->tx_nbits != SPI_NBITS_SINGLE))
- return -EINVAL;
}
/* check transfer rx_nbits */
if (xfer->rx_buf) {
@@ -1694,9 +1691,6 @@
if ((xfer->rx_nbits == SPI_NBITS_QUAD) &&
!(spi->mode & SPI_RX_QUAD))
return -EINVAL;
- if ((spi->mode & SPI_3WIRE) &&
- (xfer->rx_nbits != SPI_NBITS_SINGLE))
- return -EINVAL;
}
}