net: TCP thin linear timeouts
This patch will make TCP use only linear timeouts if the
stream is thin. This will help to avoid the very high latencies
that thin stream suffer because of exponential backoff. This
mechanism is only active if enabled by iocontrol or syscontrol
and the stream is identified as thin. A maximum of 6 linear
timeouts is tried before exponential backoff is resumed.
Signed-off-by: Andreas Petlund <apetlund@simula.no>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/Documentation/networking/ip-sysctl.txt b/Documentation/networking/ip-sysctl.txt
index 2dc7a1d..f147310 100644
--- a/Documentation/networking/ip-sysctl.txt
+++ b/Documentation/networking/ip-sysctl.txt
@@ -487,6 +487,18 @@
and CONFIG_NET_DMA is enabled.
Default: 4096
+tcp_thin_linear_timeouts - BOOLEAN
+ Enable dynamic triggering of linear timeouts for thin streams.
+ If set, a check is performed upon retransmission by timeout to
+ determine if the stream is thin (less than 4 packets in flight).
+ As long as the stream is found to be thin, up to 6 linear
+ timeouts may be performed before exponential backoff mode is
+ initiated. This improves retransmission latency for
+ non-aggressive thin streams, often found to be time-dependent.
+ For more information on thin streams, see
+ Documentation/networking/tcp-thin.txt
+ Default: 0
+
UDP variables:
udp_mem - vector of 3 INTEGERs: min, pressure, max