blob: f5e9fd8e37b4fc0d4e2657ba3739ea2d78aa7151 [file] [log] [blame]
/* arch/arm/mach-exynos4/include/mach/entry-macro.S
*
* Cloned from arch/arm/mach-realview/include/mach/entry-macro.S
*
* Low-level IRQ helper macros for EXYNOS4 platforms
*
* This file is licensed under the terms of the GNU General Public
* License version 2. This program is licensed "as is" without any
* warranty of any kind, whether express or implied.
*/
#include <mach/hardware.h>
#include <mach/map.h>
#include <asm/hardware/gic.h>
.macro disable_fiq
.endm
.macro get_irqnr_preamble, base, tmp
mov \tmp, #0
mrc p15, 0, \base, c0, c0, 5
and \base, \base, #3
cmp \base, #0
beq 1f
ldr \tmp, =gic_bank_offset
ldr \tmp, [\tmp]
cmp \base, #1
beq 1f
cmp \base, #2
addeq \tmp, \tmp, \tmp
addne \tmp, \tmp, \tmp, LSL #1
1: ldr \base, =gic_cpu_base_addr
ldr \base, [\base]
add \base, \base, \tmp
.endm
.macro arch_ret_to_user, tmp1, tmp2
.endm
/*
* The interrupt numbering scheme is defined in the
* interrupt controller spec. To wit:
*
* Interrupts 0-15 are IPI
* 16-28 are reserved
* 29-31 are local. We allow 30 to be used for the watchdog.
* 32-1020 are global
* 1021-1022 are reserved
* 1023 is "spurious" (no interrupt)
*
* For now, we ignore all local interrupts so only return an interrupt if it's
* between 30 and 1020. The test_for_ipi routine below will pick up on IPIs.
*
* A simple read from the controller will tell us the number of the highest
* priority enabled interrupt. We then just need to check whether it is in the
* valid range for an IRQ (30-1020 inclusive).
*/
.macro get_irqnr_and_base, irqnr, irqstat, base, tmp
ldr \irqstat, [\base, #GIC_CPU_INTACK] /* bits 12-10 = src CPU, 9-0 = int # */
ldr \tmp, =1021
bic \irqnr, \irqstat, #0x1c00
cmp \irqnr, #15
cmpcc \irqnr, \irqnr
cmpne \irqnr, \tmp
cmpcs \irqnr, \irqnr
addne \irqnr, \irqnr, #32
.endm
/* We assume that irqstat (the raw value of the IRQ acknowledge
* register) is preserved from the macro above.
* If there is an IPI, we immediately signal end of interrupt on the
* controller, since this requires the original irqstat value which
* we won't easily be able to recreate later.
*/
.macro test_for_ipi, irqnr, irqstat, base, tmp
bic \irqnr, \irqstat, #0x1c00
cmp \irqnr, #16
strcc \irqstat, [\base, #GIC_CPU_EOI]
cmpcs \irqnr, \irqnr
.endm