be2net: Add error recovery during load for Lancer
Add error recovery during load for Lancer
Signed-off-by: Padmanabh Ratnakar <padmanabh.ratnakar@emulex.com>
Signed-off-by: Sathya Perla <sathya.perla@emulex.com>
Signed-off-by: Subramanian Seetharaman <subbu.seetharaman@emulex.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/benet/be_hw.h b/drivers/net/benet/be_hw.h
index 3f459f7..dbe67f3 100644
--- a/drivers/net/benet/be_hw.h
+++ b/drivers/net/benet/be_hw.h
@@ -44,6 +44,18 @@
#define POST_STAGE_BE_RESET 0x3 /* Host wants to reset chip */
#define POST_STAGE_ARMFW_RDY 0xc000 /* FW is done with POST */
+
+/* Lancer SLIPORT_CONTROL SLIPORT_STATUS registers */
+#define SLIPORT_STATUS_OFFSET 0x404
+#define SLIPORT_CONTROL_OFFSET 0x408
+
+#define SLIPORT_STATUS_ERR_MASK 0x80000000
+#define SLIPORT_STATUS_RN_MASK 0x01000000
+#define SLIPORT_STATUS_RDY_MASK 0x00800000
+
+
+#define SLI_PORT_CONTROL_IP_MASK 0x08000000
+
/********* Memory BAR register ************/
#define PCICFG_MEMBAR_CTRL_INT_CTRL_OFFSET 0xfc
/* Host Interrupt Enable, if set interrupts are enabled although "PCI Interrupt