x86: big ticket locks
This implements ticket lock support for more than 255 CPUs on x86. The
code gets switched according to the configured NR_CPUS.
Signed-off-by: Nick Piggin <npiggin@suse.de>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
diff --git a/include/asm-x86/spinlock.h b/include/asm-x86/spinlock.h
index 2076d5d..23804c1 100644
--- a/include/asm-x86/spinlock.h
+++ b/include/asm-x86/spinlock.h
@@ -35,10 +35,35 @@
# define LOCK_PTR_REG "D"
#endif
-#if (NR_CPUS > 256)
-#error spinlock supports a maximum of 256 CPUs
+#if defined(CONFIG_X86_32) && \
+ (defined(CONFIG_X86_OOSTORE) || defined(CONFIG_X86_PPRO_FENCE))
+/*
+ * On PPro SMP or if we are using OOSTORE, we use a locked operation to unlock
+ * (PPro errata 66, 92)
+ */
+# define UNLOCK_LOCK_PREFIX LOCK_PREFIX
+#else
+# define UNLOCK_LOCK_PREFIX
#endif
+/*
+ * Ticket locks are conceptually two parts, one indicating the current head of
+ * the queue, and the other indicating the current tail. The lock is acquired
+ * by atomically noting the tail and incrementing it by one (thus adding
+ * ourself to the queue and noting our position), then waiting until the head
+ * becomes equal to the the initial value of the tail.
+ *
+ * We use an xadd covering *both* parts of the lock, to increment the tail and
+ * also load the position of the head, which takes care of memory ordering
+ * issues and should be optimal for the uncontended case. Note the tail must be
+ * in the high part, because a wide xadd increment of the low part would carry
+ * up and contaminate the high part.
+ *
+ * With fewer than 2^8 possible CPUs, we can use x86's partial registers to
+ * save some instructions and make the code more elegant. There really isn't
+ * much between them in performance though, especially as locks are out of line.
+ */
+#if (NR_CPUS < 256)
static inline int __raw_spin_is_locked(raw_spinlock_t *lock)
{
int tmp = *(volatile signed int *)(&(lock)->slock);
@@ -57,21 +82,6 @@
{
short inc = 0x0100;
- /*
- * Ticket locks are conceptually two bytes, one indicating the current
- * head of the queue, and the other indicating the current tail. The
- * lock is acquired by atomically noting the tail and incrementing it
- * by one (thus adding ourself to the queue and noting our position),
- * then waiting until the head becomes equal to the the initial value
- * of the tail.
- *
- * This uses a 16-bit xadd to increment the tail and also load the
- * position of the head, which takes care of memory ordering issues
- * and should be optimal for the uncontended case. Note the tail must
- * be in the high byte, otherwise the 16-bit wide increment of the low
- * byte would carry up and contaminate the high byte.
- */
-
__asm__ __volatile__ (
LOCK_PREFIX "xaddw %w0, %1\n"
"1:\t"
@@ -111,17 +121,6 @@
return tmp;
}
-#if defined(CONFIG_X86_32) && \
- (defined(CONFIG_X86_OOSTORE) || defined(CONFIG_X86_PPRO_FENCE))
-/*
- * On PPro SMP or if we are using OOSTORE, we use a locked operation to unlock
- * (PPro errata 66, 92)
- */
-# define UNLOCK_LOCK_PREFIX LOCK_PREFIX
-#else
-# define UNLOCK_LOCK_PREFIX
-#endif
-
static inline void __raw_spin_unlock(raw_spinlock_t *lock)
{
__asm__ __volatile__(
@@ -130,6 +129,77 @@
:
:"memory", "cc");
}
+#else
+static inline int __raw_spin_is_locked(raw_spinlock_t *lock)
+{
+ int tmp = *(volatile signed int *)(&(lock)->slock);
+
+ return (((tmp >> 16) & 0xffff) != (tmp & 0xffff));
+}
+
+static inline int __raw_spin_is_contended(raw_spinlock_t *lock)
+{
+ int tmp = *(volatile signed int *)(&(lock)->slock);
+
+ return (((tmp >> 16) & 0xffff) - (tmp & 0xffff)) > 1;
+}
+
+static inline void __raw_spin_lock(raw_spinlock_t *lock)
+{
+ int inc = 0x00010000;
+ int tmp;
+
+ __asm__ __volatile__ (
+ "lock ; xaddl %0, %1\n"
+ "movzwl %w0, %2\n\t"
+ "shrl $16, %0\n\t"
+ "1:\t"
+ "cmpl %0, %2\n\t"
+ "je 2f\n\t"
+ "rep ; nop\n\t"
+ "movzwl %1, %2\n\t"
+ /* don't need lfence here, because loads are in-order */
+ "jmp 1b\n"
+ "2:"
+ :"+Q" (inc), "+m" (lock->slock), "=r" (tmp)
+ :
+ :"memory", "cc");
+}
+
+#define __raw_spin_lock_flags(lock, flags) __raw_spin_lock(lock)
+
+static inline int __raw_spin_trylock(raw_spinlock_t *lock)
+{
+ int tmp;
+ int new;
+
+ asm volatile(
+ "movl %2,%0\n\t"
+ "movl %0,%1\n\t"
+ "roll $16, %0\n\t"
+ "cmpl %0,%1\n\t"
+ "jne 1f\n\t"
+ "addl $0x00010000, %1\n\t"
+ "lock ; cmpxchgl %1,%2\n\t"
+ "1:"
+ "sete %b1\n\t"
+ "movzbl %b1,%0\n\t"
+ :"=&a" (tmp), "=r" (new), "+m" (lock->slock)
+ :
+ : "memory", "cc");
+
+ return tmp;
+}
+
+static inline void __raw_spin_unlock(raw_spinlock_t *lock)
+{
+ __asm__ __volatile__(
+ UNLOCK_LOCK_PREFIX "incw %0"
+ :"+m" (lock->slock)
+ :
+ :"memory", "cc");
+}
+#endif
static inline void __raw_spin_unlock_wait(raw_spinlock_t *lock)
{