ASoC: fsl-ssi: Use generic DMA bindings if possible
There may be some platforms using fsl-ssi that do not have a DMA driver
with generic DMA bindings. So this patch adds support for the generic
DMA bindings, while still accepting the old "fsl,dma-events" property if
"dmas" is not found.
Signed-off-by: Markus Pargmann <mpa@pengutronix.de>
Tested-by: Shawn Guo <shawn.guo@linaro.org>
Signed-off-by: Mark Brown <broonie@linaro.org>
diff --git a/Documentation/devicetree/bindings/sound/fsl,ssi.txt b/Documentation/devicetree/bindings/sound/fsl,ssi.txt
index e45cbce..088a2c0 100644
--- a/Documentation/devicetree/bindings/sound/fsl,ssi.txt
+++ b/Documentation/devicetree/bindings/sound/fsl,ssi.txt
@@ -51,6 +51,10 @@
filter the codec stream. This is necessary for some boards
where an incompatible codec is connected to this SSI, e.g.
on pca100 and pcm043.
+- dmas: Generic dma devicetree binding as described in
+ Documentation/devicetree/bindings/dma/dma.txt.
+- dma-names: Two dmas have to be defined, "tx" and "rx", if fsl,imx-fiq
+ is not defined.
Child 'codec' node required properties:
- compatible: Compatible list, contains the name of the codec
diff --git a/sound/soc/fsl/fsl_ssi.c b/sound/soc/fsl/fsl_ssi.c
index 8b075ef..0c072ff 100644
--- a/sound/soc/fsl/fsl_ssi.c
+++ b/sound/soc/fsl/fsl_ssi.c
@@ -794,15 +794,19 @@
&ssi_private->filter_data_tx;
ssi_private->dma_params_rx.filter_data =
&ssi_private->filter_data_rx;
- /*
- * TODO: This is a temporary solution and should be changed
- * to use generic DMA binding later when the helplers get in.
- */
- ret = of_property_read_u32_array(pdev->dev.of_node,
+ if (!of_property_read_bool(pdev->dev.of_node, "dmas") &&
+ ssi_private->use_dma) {
+ /*
+ * FIXME: This is a temporary solution until all
+ * necessary dma drivers support the generic dma
+ * bindings.
+ */
+ ret = of_property_read_u32_array(pdev->dev.of_node,
"fsl,ssi-dma-events", dma_events, 2);
- if (ret && !ssi_private->use_dma) {
- dev_err(&pdev->dev, "could not get dma events\n");
- goto error_clk;
+ if (ret && ssi_private->use_dma) {
+ dev_err(&pdev->dev, "could not get dma events but fsl-ssi is configured to use DMA\n");
+ goto error_clk;
+ }
}
shared = of_device_is_compatible(of_get_parent(np),