USB: EHCI: OMAP: Finish ehci omap phy reset cycle before adding hcd.
'ARM: OMAP3: USB: Fix the EHCI ULPI PHY reset issue' (1fcb57d0f) created a regression
with Beagleboard xM if booting the kernel after running 'usb start' under u-boot.
Finishing the reset before calling 'usb_add_hcd' fixes the regression. This is most likely due to
usb_add_hcd calling the driver's reset and init functions which expect the hardware to be
up and running.
Signed-off-by: Russ Dill <Russ.Dill@ti.com>
Acked-by: Felipe Balbi <balbi@ti.com>
Cc: stable <stable@vger.kernel.org> [3.4]
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
diff --git a/drivers/usb/host/ehci-omap.c b/drivers/usb/host/ehci-omap.c
index 5c78f9e..e669c6a 100644
--- a/drivers/usb/host/ehci-omap.c
+++ b/drivers/usb/host/ehci-omap.c
@@ -242,15 +242,6 @@
ehci_reset(omap_ehci);
- ret = usb_add_hcd(hcd, irq, IRQF_SHARED);
- if (ret) {
- dev_err(dev, "failed to add hcd with err %d\n", ret);
- goto err_add_hcd;
- }
-
- /* root ports should always stay powered */
- ehci_port_power(omap_ehci, 1);
-
if (pdata->phy_reset) {
/* Hold the PHY in RESET for enough time till
* PHY is settled and ready
@@ -264,6 +255,15 @@
gpio_set_value(pdata->reset_gpio_port[1], 1);
}
+ ret = usb_add_hcd(hcd, irq, IRQF_SHARED);
+ if (ret) {
+ dev_err(dev, "failed to add hcd with err %d\n", ret);
+ goto err_add_hcd;
+ }
+
+ /* root ports should always stay powered */
+ ehci_port_power(omap_ehci, 1);
+
return 0;
err_add_hcd: