bonding: move processing of recv handlers into handle_frame()
Since now when bonding uses rx_handler, all traffic going into bond
device goes thru bond_handle_frame. So there's no need to go back into
bonding code later via ptype handlers. This patch converts
original ptype handlers into "bonding receive probes". These functions
are called from bond_handle_frame and they are registered per-mode.
Note that vlan packets are also handled because they are always untagged
thanks to vlan_untag()
Note that this also allows arpmon for eth-bond-bridge-vlan topology.
Signed-off-by: Jiri Pirko <jpirko@redhat.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/bonding/bond_3ad.h b/drivers/net/bonding/bond_3ad.h
index b28baff..291dbd4 100644
--- a/drivers/net/bonding/bond_3ad.h
+++ b/drivers/net/bonding/bond_3ad.h
@@ -258,7 +258,6 @@
* requested
*/
struct timer_list ad_timer;
- struct packet_type ad_pkt_type;
};
struct ad_slave_info {
@@ -280,7 +279,8 @@
void bond_3ad_handle_link_change(struct slave *slave, char link);
int bond_3ad_get_active_agg_info(struct bonding *bond, struct ad_info *ad_info);
int bond_3ad_xmit_xor(struct sk_buff *skb, struct net_device *dev);
-int bond_3ad_lacpdu_recv(struct sk_buff *skb, struct net_device *dev, struct packet_type* ptype, struct net_device *orig_dev);
+void bond_3ad_lacpdu_recv(struct sk_buff *skb, struct bonding *bond,
+ struct slave *slave);
int bond_3ad_set_carrier(struct bonding *bond);
#endif //__BOND_3AD_H__