I2C: OMAP: Handle error check for pm runtime
If PM runtime get_sync fails return with the error
so that no further reads/writes goes through the interface.
This will avoid possible abort. Add a error message in case
of failure with the cause of the failure.
Reviewed-by: Kevin Hilman <khilman@ti.com>
Signed-off-by: Shubhrajyoti D <shubhrajyoti@ti.com>
Signed-off-by: Wolfram Sang <w.sang@pengutronix.de>
diff --git a/drivers/i2c/busses/i2c-omap.c b/drivers/i2c/busses/i2c-omap.c
index 44e8cfa..c39b72f4a 100644
--- a/drivers/i2c/busses/i2c-omap.c
+++ b/drivers/i2c/busses/i2c-omap.c
@@ -585,7 +585,9 @@
int i;
int r;
- pm_runtime_get_sync(dev->dev);
+ r = pm_runtime_get_sync(dev->dev);
+ if (IS_ERR_VALUE(r))
+ return r;
r = omap_i2c_wait_for_bb(dev);
if (r < 0)
@@ -1011,7 +1013,9 @@
dev->regs = (u8 *)reg_map_ip_v1;
pm_runtime_enable(dev->dev);
- pm_runtime_get_sync(dev->dev);
+ r = pm_runtime_get_sync(dev->dev);
+ if (IS_ERR_VALUE(r))
+ goto err_free_mem;
dev->rev = omap_i2c_read_reg(dev, OMAP_I2C_REV_REG) & 0xff;
@@ -1103,12 +1107,16 @@
{
struct omap_i2c_dev *dev = platform_get_drvdata(pdev);
struct resource *mem;
+ int ret;
platform_set_drvdata(pdev, NULL);
free_irq(dev->irq, dev);
i2c_del_adapter(&dev->adapter);
- pm_runtime_get_sync(&pdev->dev);
+ ret = pm_runtime_get_sync(&pdev->dev);
+ if (IS_ERR_VALUE(ret))
+ return ret;
+
omap_i2c_write_reg(dev, OMAP_I2C_CON_REG, 0);
pm_runtime_put(&pdev->dev);
pm_runtime_disable(&pdev->dev);